I am using a pre-burn type combustion vessel to diagnostic fuel spray combustion. My premixed gasses are acetylene, oxygen, and nitrogen. My combustion vessel pressure rating is around 150bar. However for safety precaution, I want to install a safety valve that can handle the overpressure. let say if the pressure is increased more than 100bar; in such case which type of device is more accurate cause my pressure rise is very rapid and it will take less than one second to rise 10 to 90~100 bar.
Use pressure sensor that directly connect to intake manifold pressure sensor and then air pressure sensor see it will work
We use for our additive mixing tank a pressure relief valve. You can also use a burst disk that is made to break once the inside pressure gets above a certain level.
Hope this helps!
- Badges
- Science topic
- Similar topics
- Engineering
- Chemical Engineering