I am looking for Source Codes for NS2 and MATLAB?

More Danyal Sayahi's questions See All

Can increasing bacterial concentration in a formulation compensate for inhibition by lactobacillus strain,and if so ,is it right to do so?

I am conducting research on the antimicrobial synergism activity of lactobacillus strain with B.subtilis. in a recent experiment, we observed inhibition of B.subtilis growth with high...

01 June 2024 338 2 View

Can anyone offer advice on how to show the inhibition zone of bacillus against s.aureus?

Hi, i am doing research on the potential antimicrobial activity of Bacillus against s.aureus.i have tried various methods for six months.. like soft agar overlay method but my bacillus colony keep...

26 May 2024 2,151 6 View

How can I apply an electric or magnetic field to a cluster?

I want to apply a field to a cluster by VASP, how can I provide a suitable INCAR for this? And if this calculation needs other point, please advise me.

19 October 2023 6,938 3 View

How can i provide a suitable INCAR (EDIFF, EDIFFG) for optimize a cluster by VASP?

I have been running a job by VASP. My structure is a cluster(46 atoms) + one metal. when i want to optimize it, at the middle of the run, i saw this message: please rerun with smaller EDIFF, or...

15 August 2023 9,362 6 View

How can find cut off for chronopotentiometery?

I use GPES software in Autolab instrument. when i set cut off in chronopotentiometery to investigate charge/discharge of supercapacitor, the potential not receive to the determined cut off. how...

05 January 2021 2,714 4 View

How to change lysosomal pH using ammonium chloride or chloroquine?

I have been trying to change lysosomal pH using ammonium chloride or chloroquine for a while now but I haven't had much luck. I am measuring the increase in pH using ratiometric analysis where I...

20 July 2020 8,776 0 View

How do we study surface electromagnetic waves propagation in canonical problem in simulation softwares?

The canonical problems are studied using numerical techniques for formulation of dispersion relation. I wonder if these structures could be studied in simulation and comparisons be made.

08 February 2019 2,661 1 View

Infection cdna clone article ?

hello does anyone have a infectious clone review article ? for my thesis in plant best regards

18 April 2018 2,182 11 View

Can anyone help me about isolation pet28a..?

Dear all, .in my lab i need to isolate pet28a and i use Alkaline Lysis protocol ..but i cannot isolote this plasmid via alkaline lysis when i finish this method and run electrophoresis gel i...

17 March 2018 4,588 2 View

What enzyme is recommended for long PCR(9.5 kb)?

Herculase II Fusion DNA polymerase Elongase enzyme mix. Thermo Scientific Phusion LongAmp HotStart Taq DNA Polymerase (NEB, M0534S) Q5 from NEB Which one of these two works best? Or...

26 November 2017 619 9 View

How to find experimental demonstrations are available on MEC research using OMNET?

I attempted to find a tutorial on YouTube but couldn't locate it. Could anyone guide me on how to view simulation results for Mobile Edge Computing using the OMNET++ simulator?

06 July 2024 6,229 0 View

What are the modules needed in MEC research ?

To elaborate on my question: When implementing offloading techniques in mobile edge computing using simulators like OMNET++, how can I complete the experiment with results and visualizations? I...

03 July 2024 5,238 2 View

Is there anyone can help me with finding some samples of source codes or designed projects for OMnet++, SUMO, VANET Routing Protocol ?

I am trying to compare the performance of routing protocol like AODV, GPSR , DSDV , DYMO in VANET using OMNET++

19 May 2024 8,866 2 View

How to plot in Simu5G on Omnet++?

Dear network I need to plot instantaneous and mean End-to-end delay in D2D and eNode-based topologies? How to generate/visualise the accurate vec file data? I appreciate your help

14 May 2024 2,897 1 View

How to get subgraph of routers (in a network topology) that connected to SDN controller in Omnet++??

I am doing a project in omnet++. I connected the network to a SDN controller However I like to know how to get subgraphs of routers in a SDN network.

16 February 2024 3,553 1 View

Custom message class object sending in packet using the UdpBasicApp in omnet++ ?

i havea custom message class(Custom.msg) file with content message Custom { float xPos; float yPos; }...

12 February 2024 1,546 0 View

In OMNeT++, how do I save a simulation to later visualize the vector files (.sca and .vec)?

I am running my simulation and clicking on "Conclude Simulation," but I cannot find it in the folder "mypjt > simulations > results."

18 January 2024 4,755 0 View

Zigbee simulation Software?

Hello Everyone! I am working on a project to prevent identity theft using zigbee protocol. I am using omnet++ for simulation but I don't know how to implement Zigbee . Please if any one is...

09 September 2023 3,174 2 View

F2md code in vanet using omnet?

Please tell me if you have any references explaining the f2md code and parameters which it found in f2md code ? I read the f2md code ,but some of parameters not explained in its .

02 September 2023 2,669 0 View

How far Omnet++ and MATLAB will help in MEC research ?

Dear all. Can any one comment of Omnet++ and MATLab tool combination for implement a qualitative research findings in Mobile Edge Computing environment .I would like to simulate offloading...

12 August 2023 4,918 2 View

Himadri Nath Saha

https://networksimulationtools.com/ns2-projects/