Dear colleagues,
We recently purchased a cable to synchronise the different signals from the Biodex System 3 isokinetic through a PowerLab 8/35 DAQ and LabChart software (ADInstruments). After thorough testing, we have not been able to get the signals to appear in the software. Please, find attached the information of the cable characteristics we followed.
We contacted Biodex (USA and Spanish providers) and they told us that it was necessary to have a tool installed on the computer called Analog Signal Access Interface (ASA Utility)(https://www.biodex.com/physical-medicine/products/software-updates/legacy-software/analog-signal-access-interface).
However, they told us that everything related to the System 3 model was discontinued and they could not provide us with this software.
We would like to kindly request, if possible, if you could share with us a digital copy of the installation file of the ASA Utility. If not, we would like to know if you know of any other possible solution to this problem.
Thank you very much for the attention and help.
Hi Antonio,
I used Cybex and Biodex several times, and they work correctly. We also checked the time delay with an oscilloscope; the signals are OK for research purposes.
Do you have the Research ToolKit?
We use the same cable as proposed by you. However, you should configure the output on a specific software interface.
We bought a driver called "Research ToolKit" to do this procedure, but it happened several years ago.
Best
Andrea
Hi Andrea Monte
Thank you so much for your answer!
Actually, we do not have the Research ToolKit or ASA Utility installed on our Biodex System 3.
We contacted Biodex and ask them if they could provide us with the installation tool but they said that the System 3 was no longer supported by Biodex due to its age and they didn't have the parts anymore :(
So at the moment, we don't have any solution yet.
Best regards.
Antonio
- Badges
- Science topic
- Similar topics
- Psychology