Hi, i have simulate 9 bus system and do single line outage.. after that i perform load flow solution.. my problem is how to see the thermal line limit (%) result using the powerworld?
I am working with a project of early detection of cascading collapse in power system during steady state condition using neural network approach. However, I have a problem with finding a data for...
04 May 2015 5,831 7 View
hi.. currently i'm doing a project based on early detection of cascading collapse on power system using neural network approach.. however, i have a problem in finding a data set that i can use.....
04 May 2015 7,538 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
03 March 2021 8,272 1 View
Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...
02 March 2021 2,431 3 View
I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...
02 March 2021 1,408 1 View
Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...
02 March 2021 4,910 3 View
Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...
02 March 2021 1,999 5 View
In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?
01 March 2021 1,923 3 View