I want to determine through simulation in COMSOL the displacements due to applied forces. The sensor has 4 bottom and 4 top electrodes that do not complete align along with a bump on top which will be where the force is applied.
I used the capacitive pressure sensor model of COMSOL as guideline and tried to implement the component coupling average and integration. Ideally It would be possible to see the displacement of each of the top electrodes.
How can I plot the displacement of the electrodes versus the force? And which selections should I make in order to correctly visualize the displacement?
This is really good question, I am doing some similar simulations but have different boundaries for load. I am sure there should be some solution what you are looking but you can also ask the COMSOL support center as they are very helpful.
Hi Muhammed,
Thanks for your response. I have asked the COMSOL support center but no answer yet!
Dear Camilla Spaan,
It would be easy to understand and answer your problem, If you can share your .mph file (it can be a test file).
- Badges
- Science topic
- Similar topics
- Force