Fist，It is sorry to say that I did not use the CHI608E instruments.

But I do use the CHI660E & CHI760E to measure the electrochemical performance of supercapacitors. And I thought it might be the same.

In CHI660E model work stations. The Galvanostatic Charge/Discharge measurement was test by Chronopotentiometry (CP) method.

In this method, the cathodic current and anodic current are the current value of the test process. After set the High E limit and Low E limit, it is necessary to set the Initial polarity (which is your electrode for positive charge or negative charge) and the Number of Segments (it should be noticed that 2 segments equals to one charge/discharge process) to finish the setting process.

Then, press 'run' button to run the test.

Hopefully, it will be helpful for you.

I am really thank to you Yingxi Zhang , for timely helping your answer/suggestion/reply.

CHI660E & CHI760E model instruments all are related to CH instruments electro-chemical instrument CHI608E. Really helpful your answer step by step procedure.

kindly, small clarification for Which software used for above mentioned CHI660E & CHI760E or CHI608E.

Thanks lot.

Hello,

I am using CHI660D for electrochemical measurements for supercapacitor. I don't dont know about the one which you are using but the procedure is the same as sir Yingxi Zhang mentioned you