how to measure/plot DNL and INL of ADC in tanner EDA?
When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...
28 February 2021 2,133 3 View
I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...
28 February 2021 4,890 3 View
25 February 2021 1,987 3 View
Could the "incoming solar radiation" values be negative? What is the difference between "global solar radiation" and "incoming solar radiation"? Which one might be measured negative values?
21 February 2021 7,726 9 View
I want Researchers from Educational Measurement and Evaluation, relating to teaching, learning , academic performance and test validation
18 February 2021 4,757 13 View
Hi everyone, I work at a factory plant where they use a mass balance. The problem is that there is an huge difference between the input and output of one element. There are several people working...
10 February 2021 5,764 3 View
Is it possible to attain IC50 if my target cells have less than 50% antigen expression ? For example: Cancer cell line XXX is showing 35% of expression of cell surface antigen YYYY, if i...
04 February 2021 2,711 3 View
Hello researchers, I was wondering if anyone had experience in the following: I would like to translate two separate continuous biomarkers (A and B), that are mechanistically linked to each...
25 January 2021 2,107 3 View
Hi, These are the outputs generated by a system. Green-colored (nr) is desired output, while the system generates Red-colored (nf). I also have a dataset in CSV file. For this waveform, What...
21 January 2021 929 2 View
I am trying to lower the RMSE of my model as much as I can and I am wondering if there is a way to estimate the lowest it can get based on general characteristics of the model. (e.g. the amount of...
19 January 2021 5,931 3 View