What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Is IMPACT FACTOR justified in case of Taxonomy?

There is huge pressure of getting good impact factor on scholars now a days. On the other hand Taxonomy is a very dry subject and the concerned papers can only get citation in same group of organism.

26 February 2021 5,851 1 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

SSR primers are species specific or we can use it for any plant species ?

Hi, any one please guide me; SSR primers are species specific or trait specific. i have few primer which was reported in articles for wheat yield can i use these similar primer for lentil yield...

20 February 2021 315 4 View

How is Initial GDP measured ?

Dear All, I am working on estimating Debt-Growth Threshold but confused about some points. My questions are; - How do we calculate initial GDP Per Capita? Shall we do it in STATA or excel file?...

15 February 2021 2,677 2 View

How to get actual or true SoC while predicting SoC for Batteries using Data Driven Approaches?

I have seen it in multiple research articles that authors use certain approaches to predict electric vehicle battery's state of charge(SoC) and then they compare it with battery's true SoC. So I...

11 February 2021 9,070 3 View

Hi Everyone. I want to conduct DEMATEL analysis for my survey. Everything is in line except the MAXIMUM MEAN DE-ENTROPY (MMDE) ALGORITHM. Need help ?

I can't find any manual or procedure on how to conduct the MMDE process. It looks like most of the literature has copy-pasted the stuff without any method of how to do to it. Any practical book,...

07 January 2021 1,804 2 View

Anyone have any knowledge about the authenticity of the European Journal of Humanities and Social Sciences - (EJ-SOCIAL)?

https://ej-social.org/index.php/ejsocial

30 December 2020 6,845 3 View

How fishery by-products/fish waste can be utilised as efficiently, cost-effectively and eco-friendly?

Fishery by-products utilisation in the industry with minimum cost and low carbon emissions.

29 December 2020 1,752 11 View

Techniques of Machine/Deep Learning for Battery's SoC Estimation?

Hi everyone I want to know which techniques of Machine Learning/Deep Learning I can use for more accurate SOC estimation of Lithium Ion batteries. Thanks and Regards

24 December 2020 2,096 1 View

Energy minimization in LAMMPS using NVT ?

How do I do energy minimization in lammps with NVT ensemble ? I am using the following command and it does not seem to work. It stops at extremely high energy and gives me the error zero search...

01 March 2021 2,294 3 View

Why is the sum of the elements in a row in a Q matrix equal to zero?

When explaining substitution models, the substitutions are expressed as Q matrix. Why is the sum of the elements in a row zero?

28 February 2021 3,864 3 View

Which transition metal salt precursor is best for doping? Why?

I would like to synthesize a transition metal doped TiO2 via solgel method. Hence, I would like to know which metal salt precursor to choose among Chloride, Nitrate, and Sulphate. A clear...

27 February 2021 4,285 3 View

Why the CHi^2 is close to zero with a bad fitting but the Rp and Rwp are still high?

I am refining my XRD data using in FullProf program. The intensity of the modulated X-ray peaks is almost flat. I tried to adjust the peak intensities but unsuccessful. What is the reason? I guess...

23 February 2021 2,304 4 View

Can we use a compensation matrix with single staining that the negative population for each single staining is below zero?

Recently we used single staining to make a compensation matrix. But, for each single staining we saw that 13 to 25 percent of our negative population had been shown below Zero. In this situation...

21 February 2021 9,982 2 View

When I reacted Bidentate NS Schiff Base with metal salt (M-Cl2) in +2 oxidation state in proportion of (2:1) , getting sticky product ,, why?

When I reacted Bidentate NS Schiff Base with metal salt (M-Cl2) metal chlorides in +2 oxidation state in proportion of (2:1 Schiff base &metal salt) , i was get sticky material Why ? ---~...

21 February 2021 7,970 5 View

How to compare means of continuous data with zero-inflation and skew?

I have two groups (unpaired) of plant biomass measurements and want to know whether there is a test that can be used to determine statistical significance where assumptions are not violated. The...

18 February 2021 1,258 4 View

What does it mean if in mediation analysis the indirect effect is significant but is a larger b value than that of the direct effect?

I understand that for partial mediation to have occured the CI for the indirect effect must not cross zero and the b value for the indirect effect should be smaller than the b value for the direct...

14 February 2021 3,273 7 View

Passivation of chromium cast Iron in high temperature?

14 February 2021 2,157 3 View

Charmm/GROMACS Residue 'ZN' not found in residue topology database?

I am trying to do some MD simulations of a protein with zinc ions. I am trying to use a charmm forcefield (I have tried 2017 and 2021) and Gromacs. I get an error when doing pdb2gmx Residue 'ZN'...

12 February 2021 9,367 2 View