How to implement MRC combiner in MATLAB?

18 February 2019 0 3K Report

Hi,

i would like to implement Maximum Ratio Combiner with two transmitters and two receivers in order to obtain one signal at the output of the combiner.

For more details i add the figure below.

Badges
Science topic

More Amani Aloui's questions See All

What are the exact commands on STATA 16 to conduct a meta-analysis of prevalence data?

I want to do meta-analysis to estimate the pooled prevalence of diseases for a certain population. Some studies have reported their findings as a % with CI. However the majority have reported...

14 August 2020 3,615 7 View

How to obtain the saturation point of a soil layer from the volumetric soil water content data?

Hi Would you please let me know if the following is accurate as an answer to the question: Suppose we have sensors which measure the volumetric soil water content of a soil layer for a long...

01 August 2020 8,337 3 View

Are there any publicly accessible datasets for observed/measured snowfall rate?

Hi Do you any publicly accessible ground observations which have both solid and liquid precipitation rate? Preferably for many sites in different regions. Assuming that ground measured data...

01 August 2020 9,485 3 View

Can you recommend me a journal for diabetes research in Netherland or Europe with impact factor between 2-3 ?

Hi. Please introduce me a magazine(s) that is free to print with impact factor 2-3 in the field of diabetes. thanks a lot.

20 March 2020 7,373 9 View

SSMIS wind data?

Does anyone know where I can bulk download near real time (NRT) SSMIS wind data? I know several data providers, such as CLASS NOAA, OSPO NOAA, and Remote Sensing Systems, but these are not NRT or...

26 September 2019 5,729 2 View

What is the advantage of Artificial Neural Network against regression techniques?

What is the advantage of Artificial Neural Network against regression techniques

08 June 2019 3,820 6 View

Is relation between NRG1 and neuropathic pain in STZ diabetic rats?

12 February 2019 9,041 2 View

How ca I relate between lattice strain and XRD chart andnWhat is the relation between lattice strain and the activity of the studied material?

We work in the field of catalysts for fuel cells and our work mainly related to chemistry but comment on a paper wants details about lattices strain calculations which is not our study scope

16 October 2018 10,011 2 View

Any suggestion for green-space planning (master plan) of a city?

Dear experts, I am going to work on a project related to urban green-space planning. I welcome and appreciate your suggestions and comments. The key purpose of the project is to map and analyze...

15 October 2018 5,308 3 View

Hi, i would like to ask about matlab code of ABCD matrix of a network with three barnches ?

Hi, i would like to ask about matlab code of ABCD matrix of a network with three barnches to model my channel

30 November 2017 1,809 0 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Multi effect distillation modeling in EES?

Dear colleagues If anyone has a model of multi-effect distillation in EES or MATLAB software, please send it to me.

24 February 2021 7,282 1 View

What program can I use to caclulate dipole moment efficiently and without the need of excessive computation?

Hi, I am a third year chemistry undergrad doing my group project in which I need to predict the HPLC retention time of 20 aromatic molecules. to do this we require the chemical properties of these...

24 February 2021 1,384 3 View

Does anyone ever solved this following Matlab error : "Error using imaqdevice/start (line 95) pointgrey: Failed to stop the camera acquisition." ?

I use Matlab 2014b to capture some images with a PointGrey camera connected with USB3 port. I initialize the camera in a function which basically execute these followed lines : vid =...

22 February 2021 6,386 1 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View