Hi
How to give Irrigation source location ?
While I am giving my management operations(like irrigation), I need to specify the source and location of source and I am copying the same. The same properties(as i mentioned in above image) to remaining HRUs by checking the EXTEND TO ALL HRUS or EXTEND TO SELECTED HRUS.
My question is:
when I copied the same properties to remaining HRUS, whether other HRUS or sub basins will consider the location of irrigation source as sub basin 1(which i gave for sub basin 1) for remaining HRUS also ?
In the above case I gave source location as sub basin 1, when I copied the properties to remaining HRUS or sub basins, will they extract the water from reach in sub basin 1 or they will take from nearest one ?
And is there any sequence order to give management operations while editing management file ?
Regards,
Dagani
Please go through SWAT Theoretical documents, if you could not sort out the problems then i will send you a video.
Dear Binod Bhatta
Thanks for you response. I Tried several times but I am unable to get the irrigation results could you please help me in this or please send me video.
Regards,
Dagani
Dear Dagani,
If you set sub 1 they will irrigate from sub 1.
The fastest way to change or write the management parameters is using by database files. Do below steps:
You could set that parameters in ''mdb'' file.
Open your project "mdb" file in your directory (it's name is same as your project name e.g. project.mdb).
In left side of that file, find the "mgt2" and "mgt1" in these parts you can change IRR_NO and IRR_SC or what need changing.
All these changes will appear in model interface (ArcSWAT).
At least rewrite changes in model files.
Bests,
Mohammad
- Badges
- Science topic
- Similar topics
- Correction