How to get yield displacement of rebar and unconfined concrete using strain from Push Over Analysis as defined in HAZUS-MH using CSI Bridge?

01 January 1970 0 4K Report

I am Arjun Basnet, Master Student at IOE Pulchowk campus doing my thesis job on " Seismic vulnerability of Skew Bridge".

Badges
Science topic

More Arjun Basnet's questions See All

Does the presence of degenerate nucleotides in consensus sequences affect the results of population genetic analysis?

I want to run STRUCTURE on a nuclear gene of an insect species. The sequences that I have received are showing the presence of degenerate nucleotides in the consensus sequences. Do I need to edit...

29 February 2024 648 1 View

How can ML algorithms be effectively applied to optimize recruitment processes in HRM, specifically resume screening and candidate shortlisting?

The integration of artificial intelligence and machine learning (AI/ML) in Human Resource Management (HRM) has the potential to revolutionize traditional talent acquisition practices. In this...

22 January 2024 8,177 2 View

Nano urea quantity calculation per hectare?

1. How quantity of nano urea is being calculated for one hectare? (ml or Kg) 2. Is quantity calculated on ml basis or considering equivalent to conventional urea during cost of cultivation...

21 January 2024 1,048 2 View

How to use the HIOKI IM 3536 LCR meter to measure percolation threshold of CNT-rubber composites?

Hello again everyone. Does anyone have any expereience setting up an LCR meter for impedence spectroscopy. I have dispersed CNT in Rubber at increasing concentrations. Currently I am using the Z...

02 January 2024 2,037 0 View

What shall be done in case most of the Vibrating Wire Instruments Installed in your dam are not working?

Vibrating wire instruments are installed for health monitoring during dam construction. But, with time, most instruments stop working and are useless. The continuous health monitoring of the dam...

04 December 2023 9,461 4 View

How to standardize methods for determination of drug residue in tissue by HPLC?

29 November 2023 4,159 1 View

Which solvent can I use to dissolve Epichlorohydrin Rubber to cast films by doctor blade?

I have a few candidates in my mind: Propylene Carbonate, DMSO, THF and Acetone. But since it is a highly chlorinated rubber I doubt if I can use Propylene Carbonate and DMSO. I am looking to cast...

09 October 2023 9,308 0 View

Why are there no bands in pcr inspite of DNA being present?

I am trying to extract DNA from a single insect from different sites. After extraction nanodrop readings show around 12-15 nanogram per microlitre concentration which is normal for the insect....

13 August 2023 5,191 4 View

How can I link my articles on research gate to google scholar?

Because there is difference in citation score between these.

18 June 2023 4,822 1 View

What is the reason why the high N dose decreases the carbohydrate content in the leaf of plant?

In the high N the photosynthesis is also high. if photosynthesis is high then carbohydrate content of the leaf must be increased. But the different research done I found high N dose decrease the...

01 June 2023 365 1 View

Is there anyone can help me with a software that can analyse seismic data acquired using Teraloc MK8?

I have already collected seismic data and need to analyse them. Please assist with the software that can also analyse the Peak Ground ACCERATION (PGA).

10 August 2024 4,839 0 View

How can I apply boundary conditions in an orthotropic steel deck numerical model using ABAQUS software?

I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...

08 August 2024 719 0 View

Can you suggest reliable procedures to get displacements from accelerations in frequency domain ?

I have identified many solutions. I need suggestion from somebody with application experience of this topic to identify the most reliable and robust procedure.

21 July 2024 3,465 5 View

Abaqus cylinder buckling riks analysis?

hi, I am doing a risk analysis of a cylindrical fuselage with windows. I have applied contact interactions between the different parts, and I have applied a unit value load to a reference point,...

20 July 2024 647 2 View

Masonry Interaction Module ABAQUS?

I am simulating interlocking / dry stacked masonry in Abaqus. I am using a friction coefficient of 0.6 for my model as it is stated in the previous research as well as in the base paper. The...

16 July 2024 5,047 0 View

How to use stress and displacement results from 1st stationary simulation as initial conditions for 2nd eigenfrequency simulation in COMSOL?

Dear All, I am trying to define the dispersion curves of a periodic unit cell in COMSOL Multiphysics with prescribed displacements. I am using two separate studies: - Study 1: Stationary, with...

13 July 2024 7,855 1 View

Abaqus不收敛，警告里面出现下列问题，需要更改哪个地方？?

The system matrix has 172 negative eigenvalues. Displacement increment for contact is too big. Displacement increment for contact is too big. The strain increment has exceeded fifty times the...

05 July 2024 3,839 2 View

Why my mesh independent fastener as beam cartesian type not working in abaqus?

i have attached my model and i have used point based mesh independent fastener using attachment points and type of connector is basic cartesian but this is not working as i apply displacement on...

02 July 2024 6,293 0 View

Do social development programs integrate women into climate change adaptation initiatives, especially within the framework of poverty reduction?

Gender, along with socio-economic and environmental factors, is a key determinant of vulnerability to climate change.

24 June 2024 8,437 2 View

Seismic Line Interpretation in Sedimentary Basin?

I'm a PhD student researching seismic amplification in a NZ sedimentary basin. I hope that somebody will be able to help me in my interpretation of the 2D seismic lines that traverse the basin. As...

22 June 2024 5,215 3 View