How to get the current density for solid oxide electroyser in ansys fluent?

Syafawati Hasbi @Syafawati-Hasbi

06 December 2023 0 9K Report

Hi,

From the manual, there are two ways to get the current density

a) through console

b) surface integral of y current density/area

I got two different values for both approach. May I know which one is the correct one?

Thank you.

Badges
Science topic

Is there a deep reason for using the squared modulus of the wave function as the probability density of the existence of the particle?

I think we were all surprised at the first time we got to know quantum mechanics that the squared modulus of the wave function is the probability density of the existence of the particle? The role...

28 February 2021 6,282 9 View

Why do the air flow results vary totally when adding scalar in CFD ?

Dear All, We are using Autodesk cfd to calculate the air flow in a single sided naturally ventilated room, where air flow depends only on buoyancy due to temperature difference between inside and...

25 February 2021 9,602 4 View

Is there a suitable way to confine cell attachment area inside a multi-well plate?

Are there any types of cylindrical cell culture inserts that are designed to confine cell seeding area? Say, if I'm using a 12 well plate (3.5 cm^2/well), but only want to seed cells in the middle...

22 February 2021 7,127 4 View

Hi..how to isolate crude HDL (all subfractions) from human serum by size exclusion chromatography?

I would like to know about isolation of crude HDL from serum by SEC. Is it possible to perform with a serum sample volume of

19 February 2021 5,576 2 View

How to calculate the Atomic Polar Tensor using DFT ?

Dear friends, I am a beginner at DFT calculation. I have done a structure optimization using DFT- B3LYP/6-31G*, Nevertheless, I don't know How to calculate the Atomic Polar Tensor (APT) in...

17 February 2021 9,082 3 View

Measurement of water retention in organic substrates without a pressure plate?

Hello, I'm trying to measure the physical and hydrological properties of organic substrate media. Currently, I'm referring The book Soil sampling and Methods of Analysis by Carter and Gregorich....

09 February 2021 3,233 8 View

Any model suggestion for the Electronic Health Records dataset ?

I have sequentially measured the time-series Electronic Health Record patient dataset. This is 7 years of research and each patient's blood pressure, Hba1c, LDL, Hb, Baseline Age,...were measured...

09 February 2021 4,933 8 View

Does Gaussian 09W software take too long to give a result if we have a large chemical structure ?

DFT - gaussviev - gaussian09W - HOMO - LUMO

08 February 2021 6,012 5 View

Electron density difference maps(Fo-Fc): what is the meaning of negative densities (red blobs)?

Dear community, As far as I understand, negative density features point at stuff that is in the model, but not supported by experimental data. However, in many cases (e.g. attached image), when...

06 February 2021 2,847 2 View

How to calculate electrical conductivity and charge carriers density with DOS and Transmission?

Hi everyone, I'm trying to simulate some graphene nanoribbons to determine their electron mobility. I use DFTB+ for simulation software. With this software I can plot transmission in regards of...

03 February 2021 9,315 3 View