Hello, Please guide me steps for generating pressure and temperature graphs from the NVT and NPT runs in desmond? I am not able to find the steps. One of reviewer asked to generate above graph.
The political participation of the Kirat Rai community in Nepal has evolved significantly over time: Historical Context Historically, the Kirat Rai people, like many indigenous groups in Nepal,...
05 August 2024 5,950 1 View
I am doing a comparative study in which I will check the patient's progress by assessing their gait parameter, and to do that I will be using the abovementioned software. Still, before that, I...
17 July 2024 6,552 2 View
Allometric equations are available for trees but couldn't find any method/equation for ornamental plants?
04 July 2024 2,646 1 View
Hello, I got reviver comment " please look into the comparative assessments regarding Ki (inhibition constant); Kd (dissociation constant), and Km "equilibrium constant" of the target...
09 June 2024 10,069 3 View
It is a sponsored project to develop a gasket made up of FGM material and validate the nonlinear behavior of the FGM using Abaqus simulation. I was exploring the behavior of the gasket element...
25 May 2024 2,407 0 View
Such as H phase MoS2 and VS2 show same raman peaks.
08 May 2024 4,379 3 View
Sci finder helps to find out the research that has published.
30 April 2024 6,287 0 View
Design constraints such as strength requirements, and size limitations are to be considered while designing winglet
26 April 2024 6,857 2 View
Hi all, I encountered an error while running SCF with SOC+U using Quantum Espresso 7.3. Here is the error%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%% Error...
09 March 2024 9,104 4 View
Quantum Entanglement is a phenomeno inwich
03 February 2024 3,685 4 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...
06 August 2024 4,953 0 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
Hello guys! Do you have experience running a Oaxaca-Blinder decomposition on R applying person weights. How do you suggest doing it? I have a variable PERWT which gives more information on how...
04 August 2024 6,033 0 View
I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...
03 August 2024 6,070 3 View
I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...
31 July 2024 9,697 0 View
Hello Everyone I have a question about structure for connectivity analysis on sources. My goal: preprocess and cut data into trials create headmodels, using template MRI file perform source...
30 July 2024 2,744 1 View
The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...
30 July 2024 3,126 0 View
When I run autogrid4 it says: autogrid4: ERROR: Unknown receptor type: "Cr" -- Add parameters for it to the parameter library first! Look forward to your reply.Thank you so much!
29 July 2024 488 0 View
Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.
29 July 2024 4,971 1 View