How to seperate PEG-4000 from aqueuse phase ?

Hello everyone , Please tell me if It possible to seperat POlyethelyn glycol -4000 from an aqueuse media by other ways rather heating . I have tried salting out by electrolyte solution to...

22 February 2021 7,285 5 View

How to define the sink temperature and film coefficient?

Hi, everyone. I am considering the heat conviction during compacting simulation by Abaqus. I was wondering that how to define the sink temperature and film coefficient? Is there any references...

21 February 2021 6,197 1 View

Can RNAscope be used to quantify the mRNA expression level of certain genes?

Hello, all, I want to explore the mRNA expression level of certain genes in the brain under physiological and pathological conditions. In previous studies, the researchers usually isolated the...

18 February 2021 1,518 1 View

Is there any low-cost filtering system (or other tech.)to lower the salt conc. (salinity) of surface/groundwater for large scale agricultural system??

The available water (surface and groundwater) is highly saline (6-20 dS/m). It is required to produce crop (moderately saline tolerant, up to 6 dS/m). Is there any low-cost filtering system (or...

18 January 2021 5,015 3 View

What will be the life of siRNA (liquid form) at -20 degree, if kept unopened?

Hi all, I just want to know that, if we keep the siRNA in a -20 degree freezer (as mentioned in the product detail), what will be the average life of the siRNA? Can we store for more than one...

10 January 2021 6,346 6 View

Can we compare regression results (models) for different groups?

Dear Research Gate Members, I have a query regarding comparing the two groups on the basis of the regression models For Instance: I have two sector companies i.e. Public Sector and Private...

09 January 2021 9,645 8 View

How to define thermal failure in Abaqus?

Hi, everyone, I am simulate the impacting CFRP model, I want to know how to define thermal failure during the impact process because epoxy degraded owing to thermal effects. Thank you so much for...

25 December 2020 7,424 3 View

How to define thermal conductance in Abqsus?

25 December 2020 3,596 1 View

ESA Eureca spacecraft Solar Array Arcing demage, What is the cause of the problem?

We see a photos of solar array damage suffered by the ESA Eureca spacecraft that was recovered by the Space Shuttle. photo shows a sustained arc site on its solar arrays. In this case, the...

23 December 2020 2,512 2 View

Can I add or delete studies from systematic review during revision stage of paper publication?

I have conducted a systematic review and one of the reviewers had mentioned about missing out on some good studies from the sample. on the surface the study is on a different topic but after an...

21 December 2020 573 4 View

Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How does charge on working electrode changes with rising potential?

During performing CV of a GCE or modified GCE, we rise the potential in the first half of the cycle and reduce it in reverse half. During the first half, what is the nature of charge on GCE or...

25 February 2021 7,994 3 View

How to delaminate copper in water-based anodes?

Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...

24 February 2021 3,785 3 View

Thermal reduction of graphene oxide.?

I am trying to reduce graphene oxide by thermally but I have no proper information regarding this. Can any one help me regarding the details about temperature and time for the reduction of...

23 February 2021 4,155 4 View

Physical-chemical formation of stalactites/stalagmites. what promotes the formation/growth of these structures?

I know, or think I do, the basic idea behind these natural structures, as from what I know they form due to water dripping from the top leaving a salt deposit behind. But started to wonder about...

22 February 2021 1,400 4 View

What kind of steel moulds are used for hot pressing metal powders?

My main concern is that the metal powders should not weld to the mold surface and I should easily be able to eject out the pressed samples. I am looking for alternative for graphite moulds. The...

22 February 2021 2,965 4 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View

Color of spiro-ometad film?

What does the color of a spiro-ometad film indicate? I got purple, green, red, even black color of the spiro film. Is there anything we can get from the preliminary color analysis(e.g. oxidation...

21 February 2021 1,831 4 View