How to convert backscattered values from SCATSAT data into dielectric constant?

10 October 2017 0 3K Report

I want to plot graphs depicting dielectric constant vs wetness. For that, I need to convert backscattered values into dielectric constant.

Badges
Science topic

Similar topics
Mathematical Sciences
Graphs

More Satej Panditrao's questions See All

What is Climate Resilient Agriculture?

I am a researcher in Remote Sensing and working on Smart Agriculture. I want to know what is Climate Resilient Agriculture and how Remote Sensing & GIS can be implemented to achieve this.

09 October 2018 1,742 6 View

How to improve the accuracy of Crop classification?

I am working on Planet imagery (https://www.planet.com/products/planet-imagery/) consisting of Kharif and Rabi crops (Indian crop cycles in a year). I want to classify different crops per week....

05 June 2018 7,024 27 View

How to extract complex building footprints using Machine Learning and Deep Learning approaches?

I am having WorldView-2 and WorldView-3 imagery (includes SWIR bands) of dense urban areas. I want to extract building footprints (2D and 3D) of very complex buildings. For 3D, I have DSM.

04 May 2018 6,582 3 View

Regarding WorldView-3 data processing, are you done with pansharpening? Which method did you use? SWIR + PAN or SWIR +MSS +PAN??

Pan sharpening of WV-3 data is a challenge. I am struggling with this especially with SWIR and PAN fusion. How to go about it? Merging of MSS and PAN then SWIR would be very complex.

02 March 2017 5,330 5 View

What is the method of using RISAT-1 dual pol stereo data in Radargrammetry?

I want to do stereo analysis of RISAT-1 data (and other SAR datasets like TerraSAR-X, RADARSAT etc.) using Radargrammetry. How can I go about it? Which software can be used for this task? As...

05 June 2015 7,594 0 View

What is the procedure to perform Atmospheric Correction of Cartosat 2D imagery?

We want to convert DN values of Cartosat 2D (PAN and MS) imagery into Surface Reflectance. For that we need the values of bias, gain, scale factor, solar irradiance. We also want to remove Haze.

01 January 1970 2,066 3 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

How to calculate conductivity using Electrochemical Impedance Spectroscopy's Nyquist plot?

Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...

29 July 2024 1,376 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

Is there a name for this type of function?

Let n∈ℕ, where the function f:A⊆ℝ𝑛→ℝ, 𝐴 is Borel, and (A,d) is a completely seperable space. What is the name of the functions where the graph of f in any (n+1)-dimensional box of A×ℝ is...

17 July 2024 258 1 View

What is the mechanism of atmospheric pressure plasma Jet (APPJ)?

In general, the characteristic of electric current as a function of voltage in argon plasma jet using dielectric barrier discharge in atmospheric pressure, jet length will increase by the increase...

16 July 2024 9,316 1 View