Hello! I would like to set the pulse generator block in MATLAB/Simulink to obtain best waveforms of a multilevel inverter by using the fundamental switching frequency. But I can't do it! The problem is that the pulse generator block doesn't give me the correct switching patterns. I have a screen shot to better understand what I'm talking about! How can I do to configure this block for producing the switching pattern on the screen shot? Thanks a lot!
Dear Jorel,
You can find the answer of this question in my paper on stepped sine wave inverter. To get the paper please follow the link: Article “Computer-aided analysis of stepped sine wave inverters
Best wishes
Dear Jorel,
check the attached image, I hope to be useful to you.
it is an example for a 15-level inverter.
Regards
Thanks a lot for your help! I obtained the best configuration for the switching pattern. Now my multilevel wave is good. The Total Harmonic Distortion is near of 1.75% for a 31-levels.
Best wishes,
- Badges
- Science topic
- Similar topics
- Correction