What factors increase acidity of raw fresh water?

What is the reason of increasing acidity of raw fresh water, despite its high percentage of salts (suspended and dissolved), in addition to its low organic matter? Can atmospheric CO2 causes this...

14 January 2021 4,388 5 View

Can anyone send to me a free download plagiarism checker program?

I found many plagiarism programs that allow only 150 words for checking. I search for a free download plagiarism checker program (not trial). Thanks

20 March 2019 5,708 6 View

What is the scientific importance of being acknowledged in a published paper?

And can use this paper in a conference for example or add it to my cv ?

05 January 2019 7,236 3 View

No title

its not dissolve in ethanol and methanol

25 December 2018 8,694 2 View

Why flow cytometry and Qpcr are different ?

Hello everyone, I have unexplained phenomenon in my data regarding one cytokine. The level of this cytokine by Qpcr is very high in knockout more than WT mice in naive condition and after...

18 September 2018 5,644 3 View

Dear friends can you advice what are the policies required to correct the infomal Markets: correction ?

Do you think that developed countries doesn't have informal market and why government didn't interfere ?

18 June 2018 4,368 10 View

How to measure informal markets?

how to measure informal markets? what are the criteria ,index, measures. want to test macro impact across countries.

13 February 2018 6,405 2 View

How to troubleshoot isotype control for flow cytometry ?

Dear fellows, I am facing a problem using Isotype control, for example, when I run flow , the signal in un-stimulated samples is 10%, and in stimulated samples is 12%. However, the isotype...

22 November 2017 7,663 1 View

What does it mean when the same spots are developped in both reversed phase and normal phase TLC

Normal phase system is methylene chloride:methanol 9.5:0.5 Reversed phase system is methanol:water 9:1

22 May 2017 9,484 5 View

Oral salmonella infection?

03 March 2016 3,714 3 View

Energy minimization in LAMMPS using NVT ?

How do I do energy minimization in lammps with NVT ensemble ? I am using the following command and it does not seem to work. It stops at extremely high energy and gives me the error zero search...

01 March 2021 2,294 3 View

How can I edit suggested publications?

Hi there! I regularly receive suggestion about papers and authors that are totally out of my area. Does anybody know how I can fix this? Thank you!

01 March 2021 9,574 4 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

Can you perform the Murexide test on samples fixed in Formalin?

I have a fixed sample and would like to use the murexide reaction to test for uric acid composition. I no longer have fresh samples

22 February 2021 1,328 1 View

Monte Carlo simulation?

Hi, i am conducting a Monte Carlo simulation for my new distribution but the MSE values are increasing while the sample size increase, does any experience this issue before and what should i do...

22 February 2021 3,680 4 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View

How would I use a glycerol fixation to fix whole brain Drosophila tissue?

I need to take IF images with DAPI on a confocal but I need to use a glycerol fixation. Has anyone done this method before, if so how was it done? Thank you.

21 February 2021 3,081 3 View

How to call both UMAT and UEL together in Abaqus?

I have a model with bulk material (matrix) and inclusions and cohesive interface elements between both. For the bulk material, I have implemented a UMAT and for the cohesive interface elements, I...

20 February 2021 1,286 2 View

How can we study the adsorption efficiency of microgel at the oil-water interface?

I am studing the mircogel at oil-water interface. I want to know the adsorb amount of microgel at the oil water interface. How we can determine this amount?. I will highly appreciate your...

19 February 2021 2,787 1 View