How to code in Matlab Ellipse by Oblong method?

09 November 2019 1 3K Report

The Video link is given below-

https://www.youtube.com/watch?v=TNQE9vN3QJo&t=23s

Have a look at CONICS @ MATLAB ::: https://au.mathworks.com/matlabcentral/answers/429136-plot-an-ellipse-from-conic-representation

https://au.mathworks.com/matlabcentral/answers/385792-solving-conic-equation-for-a-set-of-points

and ODE:::

https://au.mathworks.com/help/matlab/ref/ode45.html

Badges
Science topic

More Sanjoy Kumar Debnath's questions See All

Why there are two peaks while using the mie plot of Silver nanoparticle?

Hi, I am trying to learn the theoretical modelling of silver nanoparticle using the Mie scattering theory. After that, I discovered a software named Mieplot developed by Philip Laven, where it...

25 February 2021 7,493 6 View

Lift off problem with Indium/Gold deposition?

Hi, I'm doing 5/40nm In/Au e-beam evaporation at rates 0.2A/s(for In),1A/s(Au) on lithographically(doubly coated 495k,950k PMMA e-beam resist) done Si substrate at base pressure 2e-6torr. I'm...

18 January 2021 7,550 4 View

How much would be the particle size difference between Malvern Zetasizer Ultra Particle Analyzer and TEM for the same Nanoparticles?

I am measuring the particle size of nanoparticles by Malvern Zetasizer Ultra Particle Analyzer but I am not sure I would get a better size with TEM or not. Because I read in a paper that there is...

05 January 2021 1,612 8 View

Which identification method is the most suitable or identification of Vibrio spp.? Molecular or Biochemical?

I have some Vibrio isolates from Brackishwater fish and environment. I am unable to identify two of them unto species level. It is showing conflict between Biochemical identification and Molecular...

03 January 2021 691 7 View

Why a distorted admitance value is obtained while doing mixed mode simulation of TFET with dyanamic non local BTBT model in Santaurus TCAD ?

AC analysis of TFET device along with dynamic non local BTBT model shows a distorted admitance. But while using Local BTBT model a good values for the admitance is observed.

20 July 2020 2,465 1 View

If a system is stable in each of the operating regions, can it be said that the system is stable for the entire operating region?

If an operating region is divided into a number of sectors and if it is shown that the system is stable in equilibrium point corresponding to each of the sectors, can it be said that the system is...

21 March 2020 8,816 6 View

Which is the best instrument for the Soil Erosion Measurement?

I want to measure the soil erosion of a watershed. Is there any instrument which will help me to measure the soil erosion?

24 February 2020 8,934 22 View

How to do optimization by neural network in matlab?

I have used 30 experimental data set for ANN modelling (Matlab) and RSM based optimization (Design Expert). The RSM and ANN predicted data was compared and it was observed that the ANN model has...

30 January 2020 7,760 3 View

Where we can find the World geochemical background values of these heavy metals Fe, Zn, Pb, Cr, Cu, Ni, Cd for calc of sediment indexes?

These background values/reference values can be used for calculation of different indexes, viz. enrichment factor, geo-accumulation index, contamination factor, pollution load index and many more.

22 January 2020 8,948 3 View

How to incorporate random uncertainty within the A-matrix represented by a gain block in Simulink?

I have a Simulink gain block that houses the A- matrix of the plant and I want to add randomness into the parameters of A-matrix. How do I achieve that in Simulink?

05 December 2019 6,127 7 View

How to code open-ended questions in SPSS?

Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...

02 March 2021 1,757 4 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

How can we simulate an hyperelastic-viscoelastic behavor with Ansys APDL?

I am working on modeling and simulation of biomecanical material behaviour, I have succeded on simulating skin using anisotropic hyperelastic material, on APDL and in our lab's finite element...

28 February 2021 552 3 View

How could I process data in RCT to include it in meta-analysis?

I'm in the process of doing a meta-analysis and have encountered some problems with the RCT data. One of my outcom is muscle strength. In one study, I have three different measurements of muscle...

25 February 2021 7,603 3 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Modeling viscosity using model of Chung?

Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...

25 February 2021 8,053 5 View

Please. Could you help be in implementing Fractal Discrete Cosine Transform algorithm in Matlab?

I do need the Matlab code of Fractal Discrete Cosine Transform (FDCT). Can anyone who has already implement this code, help me with the implementation of this transform?

24 February 2021 5,602 2 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View