How to check Block Stake of a model in FLAC3D after execution?

19 June 2023 0 8K Report

I am facing difficulty finding out the 'Block state' (plasticity indicator, i.e., elastic, plastic, and formerly plastic zones) of the executed model in FLAC 3D version 5.01. In FLAC 2D version 7.0, we can find the plasticity indicator using the 'plot hold bound plasticity' command. However, I could not be able to find out in FLAC 3D version 5.01. Any help will be highly appreciated.

Badges
Science topic

Please explain how the plastic input value should be considered from the true stress-strain curve for the bilinear elastoplastic material model ?

I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...

05 August 2024 454 3 View

What are the shear and normal stiffness values of an LLDPE liner in 3D numerical modeling of a stockpile?

I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...

05 August 2024 3,665 0 View

Water Consumption in Plastic Recycling: Is it Higher Than for Virgin Plastics?

Hello, dear colleagues, I would like your help in finding a reference that provides an average water savings due to plastic recycling compared to the consumption of virgin materials, preferably...

29 July 2024 4,630 0 View

Interpreting ATR-FTIR Spectra for Microplastics Research?

Hello everyone, I am currently pursuing a PhD in Environmental Engineering with a focus on microplastic studies. My background is in Civil Engineering, and I am relatively new to working with...

18 July 2024 7,258 3 View

How do we get the plasticity multiplier of M-C criterion in FLAC 3D?

In the Itasca FLAC3D Documentation, it provides the expression of plasticity multiplier regarding Mohr-Coulomb criterion directly, without a detailed derivation process. Could anyone share the...

12 July 2024 7,850 0 View

Why am I seeing only one initial maximum in torque-time curves for the fusion of PVC in a Brabender?

We're studying the stability and fusion behavior of multiple PVC compounds in a Brabender. After a few trials, we set the temperature at 195 °C and the rotor speed at 70 rpm. Samples differ in...

12 July 2024 2,768 1 View

What are possible reasons for having the repeated wavy patter in Raman spectrum?

I'm currently analyzing the Raman spectra of coloured plastic samples and have encountered a wavy, oscillating pattern in the spectra of some coloured samples. I was wondering what the possible...

04 July 2024 1,949 4 View

How can Abaqus CAE be utilized to assess the variation in wall thickness throughout a plastic bottle following a blow molding simulation?

Hello ResearchGate Community, How can Abaqus CAE be utilized to assess the variation in wall thickness throughout a plastic bottle following a blow molding simulation?

26 June 2024 9,281 4 View

How to overcome the stickiness of smaller molecules/peptides to the plastic/PetriDish?

Use of excess amount of BSA is already tested but has not helped us. Addition of 0.01% Tween did not help us either.

17 June 2024 5,520 1 View

What are the parameters for simulating plastic deformation cracks in concrete using the CDP model?

Dear professors and colleagues， hello！Recently, while studying the CDP model, I have read the manuscripts of various experts and have gained a lot, but I still have some questions.What I...

10 June 2024 1,906 1 View