How to calculate the power consumption using a CPU utilization model in CloudSim?

More Dilip Kumar's questions See All

How to implement swarm optimization (SO) techniques for VM scheduling in CloudSim?

I am trying to schedule the VMs into host machines using a swarm optimization (SO) technique to find an optimal solution. Can someone suggests some ideas?

02 March 2014 1,003 3 View

How to implement the genetic algorithms in CloudSim for cloudlets and VMs scheduling?

I have implemented Genetic algorithms in Matlab, now we need to simulate in CloudSim for cloudlets and VMs scheduling.

01 February 2014 7,557 4 View

Could you recommend some articles on Urban Transportation System optimization and Innovation?

13 August 2024 2,595 3 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,290 1 View

Which test should be used to study association among demographic profile and awarness level?

i have to study the awareness and adoption level of cloud computing in a district of India. i also want to use association among demographic variables like gender, age, education, income etc and...

02 August 2024 2,420 3 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

Transfection in HEK293T cells?

Dear All, I am trying to transfect a pCDNA3.1 vector containing my gene of interest. The purpose is to figure out the localization of the protein of interest. I have fused the protein with GFP on...

31 July 2024 9,892 4 View

A Question about Phd thesis?

Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...

31 July 2024 5,785 4 View

How to retain the a GFP tagged gene expression in stable cell line?

Hello , I established a stable cell line expressing GFP tagged to a centrosomal gene having G418 drug selection marker. I validated the stable line by IFA and Western blotting, results are fine....

29 July 2024 5,007 0 View

After a lot of feature engineering for CTR modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing?

After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?

29 July 2024 4,955 0 View

How to use Desmond in HPC ?

Our department has recently acquired an HPC (High-Performance Computing) system, and I'm thrilled to take my molecular dynamics calculations to the next level using Desmond. I used to run my...

28 July 2024 6,553 1 View

Dilip Kumar

http://www.spec.org have been given the utilization based real data on power consumption.

What are the other Power Models to calculate the power consumption.

Linear Power Model can be calculated as:

Power Consumed = Pmin + (Pmax - Pmin) * Utilization

where Pmin is minimum power consumed at idle state and Pmax is the maximum power consumed at peak load. Utilization is between 0 and 1.

Fateme Bemanali

how can i calculate work load of vm in cloudsim?

is there any formula ?

Nahuru Ado

Hi Prof. Dilip Kumar kindly help me out on how to calculate maximum utilization