How to calculate the hydrodynamics radius of solute particle in a polymer using LAMMPS?

Ashwani Kushwaha @Ashwani-Kushwaha

23 October 2021 0 5K Report

I am working on viscolestic properties of polymers uisng s NEMD and microrehology simulations.

Badges
Science topic

More Ashwani Kushwaha's questions See All

Can someone add Journal Impact Factor Document (JCR 2024)?

Clarivate Reveals World’s Leading and Trusted Journals with the 2024 Journal Citation Reports on 20 June 2024

19 June 2024 3,601 2 View

Minimum concentration of protein to be injected for detectable peaks of protein in 16/60 Sephacryl S-100 HR column for SEC-FPLC?

Hello Peers, Warm wishes to all. I am a new user of the Cytiva AKTA Start system for SEC with a column, HiPrep 16/60 Sephacryl S-100 HR (120 ml column volume). I am not sure about the minimum...

03 June 2024 7,713 2 View

How to split molecules into test and training set in 3D-QSAR?

Hi peers and experts! I am new to 3D-QSAR and tried to build a model based on 34 molecules, split into 10 test and 24 training sets. In the end, a poor model is evident from r2 and q2 values....

08 April 2024 2,785 6 View

During galvanostatic charge-discharge (GCD) measurements, why is the electrode not fully charged when lower currents are used ?

When applying currents ranging from 1 to 8 mA to charge my electrode, it fails to reach full charge, and instead, after some time during the charge cycle, it exhibits a straight line pattern on...

28 February 2024 1,535 3 View

What is Repeated Earthquakes?

What is the concept of repeated earthquakes? How does the dynamic analysis is performed under repeated earthquake? Is this done in a different way that IDA analysis? How the ground motion data...

02 November 2023 4,884 4 View

While doing simulation on SCAPS-1D for the CdTe/CdS solar cell, I am getting a negative QE for higher wavelength range?

I required some data for the study related to QE of solar cell, but the problem is that I am getting negative QE values at higher wavelength range or at photon energy less than the band gap of...

11 October 2023 5,729 0 View

Does the results obtained with the cracked version of SAP2000 match with licensed version of SAP2000?

I am trying to verify the results obtained by modal analysis and response analysis of a G+4 RC hill Building with the base paper results but unfortunately couldn`t. Although I have followed all...

09 October 2023 7,390 9 View

What are the technical aspects of microstrip patch antenna for space/defence applications?

Related to antennas arrays.

03 October 2023 568 2 View

Why my Ni structure is not converging after applying a strain in X-direction?

Please find the attached Ni Quantum Espresso Input file. &CONTROL calculation = 'scf' verbosity = 'high' restart_mode = 'from_scratch' tstress = .true....

11 September 2023 9,925 0 View

How is RINEX data converted to SP3 or SINEX?

Converting Rinex data to other geodetic file formats is essential for compatibility and interoperability between different software tools used in GNSS data processing and analysis. Two common...

05 August 2023 7,873 0 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

How to increase simulation box size?

We intend to study the interaction between peptides and polymer (like PP, PE and PS) through MD simulations using Martini force fields ( Martini 2 for PP and Martini 3 for PE, PS). We have...

08 August 2024 4,842 0 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 947 1 View

Polymer wear calculation?

What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?

04 August 2024 1,078 1 View

Which distribution type should I use when calculating the average particle size from TEM image? and how to calculate the error ?

average particle size calculation from TEM

04 August 2024 2,921 1 View

Who of all the Global Scientific community will help me Prof. Dr. Yoshida make way for TPEOM, MEC ~EMC to return the atmospheric gases to the norma ?

TEP presentation caption (The Environmental Project) Re: Why should Washington’s DC, or any country government point of location think of as nowadays of as to being 'tomorrow as to come! if it...

03 August 2024 2,484 1 View

How to load and plot 2D-PIV (particle image velocimetry) recorded velocity vector field in Techplot?

Dear Researchers I need to know, how to load and plot 2D-PIV (particle image velocimetry) recorded velocity vector field data in Tecplot? Thank You

02 August 2024 3,615 1 View

Does the delta function actually make sense to use on point particles?

The delta function seems produce logical contradictions when analyzed on a fundamental level. I would be curious if anyone else agrees.

31 July 2024 10,109 3 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

Why is it not common to see similar pairs in polymer sliding pairs?

If the pairs are similar, will it reduce the adhesion due to electric charges?

29 July 2024 3,185 2 View