Ceramic / Non-Polarized Capacitors
electrical engineering
11 December 2015 4,592 2 View
AC and DC Resistance
11 December 2015 1,857 1 View
Fluorescent Lamps
11 December 2015 4,531 0 View
house-lighting
11 December 2015 8,938 0 View
Solar Panel
11 December 2015 7,405 0 View
synchronous motor
11 December 2015 7,894 0 View
oil transformer
11 December 2015 4,884 0 View
If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis
02 March 2021 7,670 3 View
Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...
28 February 2021 7,882 2 View
When I run the job for TS(QST3) in gaseous phase, it was completed without any error. But when I add water in CPCM model it terminated with an error: Inconsistency: ModMin= 2 Eigenvalue=...
21 February 2021 3,198 2 View
I am working on transparent/translucent zirconia-based ceramics. In many papers, I have seen that they are reporting both In-line transmission (%) & Total transmission (%) value of...
20 February 2021 9,405 6 View
Hi all, I have a question regarding calculations using the Pfaffl method. I have 3 groups per experiment: 1 control group (calibrator) and 2 treatment groups with 6 to 7 biological repeats per...
19 February 2021 8,351 2 View
Hi, A Fabry Perot Cavity allows to increase the directivity of a low gain antenna by putting in the top of cavity a superstrate with high permittivity such as a ceramic (er=10.2). However,...
09 February 2021 6,799 8 View
Hello everyone! Is a normal value 295.8 ug/ul for cDNA? If not what does it mean? Where is the mistake? The measurement was done with nano drop. Thank you!
09 February 2021 6,202 1 View
i used to control EHO+ANFIS to MRPID to Landsman converter for bldc drive i got 7% but some of them are telling IEEE standards are < 5% is it correct for Drives ?
07 February 2021 5,892 1 View
Recommendations in preparing ceramics for nanoindentation and in the process minimize introducing stresses from sample preparation i.e. polishing stage.
02 February 2021 6,211 3 View
I have Submitted 2,3 Papers in Science Direct associated Journals but the time of the first decision has been ended so What should I do? Could I email them to remind them about the first decision?
01 February 2021 5,788 7 View
