What is the status of bread making and more bakery foods with the use of insect flour/powder?

Insects have been consumed by human diet since prehistoric times. At present, the idea of looking at insects as food has been getting traction worldwide, also in response to increasing food...

03 March 2021 6,223 5 View

Is that possible to do an impedance measurement without FRA module?

One of my colleagues said, "the impedance you can measure with the three electrodes and with the specific sequence varying the frequency" Is it possible to configure the potenciostat without the...

21 February 2021 418 2 View

How to compare two group with small sample size (n=3)?

I am working on some physiological traits of plant to which its expensive to raise the sample size beyond n=3. so kindly suggest some test which is applicable to test such group(2)

04 February 2021 461 11 View

What is the best method for removing power-line interference (PLI)?

In the paper A wavelet-based method for power-line interference removal i... we propose a new method for removing PLI. This method consists in identifying the ECG and noise frequency range for...

29 December 2020 9,233 3 View

I would like. How they can be simulated the deformational processes of valvular aortic stents??

We have a projet about TAVI

22 December 2020 7,729 1 View

Can LAMP distinguish the species from different genus/family?

I am usiing LAMP kit, specifically designed for liriomyza huidobrensis. I have a random samples of differet insects and LAMP seems to amplify insects from other Genus as well. Although, other...

07 December 2020 5,630 3 View

How to convert Terapeutic Human Doses to Cell Experimentation Doses?

"Toxicological evaluations revealed that Cur is found to be pharmacologically safe, even up to 12 g per day, as reported by several animal studies and in phase-I clinical trials Similarly,...

07 December 2020 3,012 1 View

How to calculate Area-Weighted Average Temperature at outlet in Ansys?

Suppose a fluid is flowing between two parallel plates (and exchanging heat) for 100-time steps. So, there is an area-weighted Average temperature at every 10 steps. How can I write a UDF to...

29 November 2020 6,240 2 View

How to reconcile two sets of qPCR data from the same sample but acquired with different parameters (Ta, primer cc., etc.)?

17 November 2020 4,272 3 View

No title

Hello! I'm currently studying the influence of adding a mass in a cantilever tip, near to a bifurcation. In order to do it, I simplified a model of the cantilever to a 1DOF...

06 November 2020 3,843 3 View

Handheld Portable Raman spectroscopy systems - recommendations and experience?

Hi all, I am looking for some general feedback and information from those that have experience using handheld/portable systems? I am looking at the prospects of using an off the shelf system from...

07 February 2021 9,691 3 View

Could anyone professional help me to solve this problem?

I have installed the software BRUKER Flexanalysis 3.4 on my computer successfully. But when I tried to import the MS data produced by BRUKER MALDI-TOF-MS, I met with an error described in the...

10 November 2020 8,205 1 View

How to set up the parameters on an NMR instrument to run deuterated sulfuric acid as a solvent?

I have a compound which is only stable in concentrated sulfuric acid and I'd like to get a NMR spectrum so I can deduce the structure. I use a 300 MHz Bruker instrument and the software is topspin.

25 September 2020 5,218 3 View

How can I improve the rietveld refinement model and lower the R bragg factor and chi-square?

I measured a fluconazole drug sample and found 2 phases. Then, for the first time, I tried to apply the rietveld refinement method using Match! and got relatively high values for both R bragg...

27 July 2020 9,492 4 View

The shoulder on the XRD peak. What could it be?

Dear RG community! I am obtaining very weird peaks on the XRD pattern. There is a shoulder on the left side of the peak looking like a step. Arrow on the picture. It is about 2-3% of the Ka1 peak...

25 June 2020 8,500 12 View

How to convert Bruker .BAF file to other format that can be read by "Thermo proteome discoverer" software?

Does anyone know how to convert Bruker .BAF data file to other format that can be read by "Thermo proteome discoverer" software? I have tried to convert the file using "Trans-Proteomic Pipeline"...

08 December 2019 8,851 6 View

Maximum dimensions for (Bruker) FTIR-ATR samples?

I am curious about the maximum recommended dimensions for ATR samples? I am planning to analyse several small animal bone samples and I'm hoping to have minimal preparation/fragmentation of the...

08 November 2019 1,081 1 View

Implement Topshim (Bruker NMR) shimming commands in IconNMR?

With Bruker's Topshim program, I have used the following command to shim every new sample: topshim z6 1d optsolvent coil=1H tuneb tunea Now I'd like to use IconNMR to automate this procedure,...

20 August 2019 1,111 5 View

What is the solution to the error while running MaxQuant ?

Dear all, I use label-free QTOF technique (Bruker) in my project. I got a good result at the first time I analyzed .d folder using MaxQuant version 1.6.5. However, in the last 2 months, error...

18 August 2019 5,009 6 View

What is the solution to the error while running MaxQuant ?

Dear all, I use label-free QTOF technique (Bruker) in my project. I got a good result at the first time I analyzed .d folder using MaxQuant version 1.6.5. However, in the last 2 months, error...

07 August 2019 8,318 3 View