What is Flat Lens Antenna?

28 February 2021 5,433 3 View

Can impedance of antenna be less than 50 ohms?

I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...

27 February 2021 4,218 7 View

Helix antenna coupling problem?

Dealing with a helix antenna, made with flexible material and not rigid like using a PCB board or wire. At the beginning of the helix is too close to the ground plane, causing coupling. How can I...

21 February 2021 4,453 3 View

Which method need to be used to predict crack propagation?

Need to predict the crack propagation phenomenon in a CI component. Suggestions are needed regarding the the methods ( XFEM, J integral, etc.,) which will predict the crack propagation behavior...

06 February 2021 1,936 4 View

Can anyone elaborate the method to measure arterial pulse wave velocity in research studies involving Sphygmocor??

Sphygmocor is the tonometry based instrument which is used to record generally radial pulse waves and then calculating various variables like Augmentation Index, SEVR etc. It is also used to...

02 February 2021 7,546 3 View

How to solve 1-D Wave equation?

Good day, In standard PDE literature, there are a lot of solution approaches for the 1-D wave equation initial-boundary value problem. One way is with separation of variables. Below I describe...

25 January 2021 4,876 3 View

What do you mean by 'excitation' of a plasma wave? What is the physical significance of this 'excitation'? Why is it necessary?

I have read numerous research papers on various mechanisms of excitation of surface plasma wave. But why do we need to excite a wave? Is it necessary? Can't the wave propagate without being excited?

25 January 2021 3,790 3 View

What is the best software for simulation of flow, sediment transport, and wave combination?

Dear coastal and river engineering researchers, I would appreciate some help from people who may be familiar with Flow, Sediment, and Wave related software with regards to the following: - Is it...

22 January 2021 6,024 14 View

In opensees is the ReinforcingSteel material sensitive to units of measure?

20 January 2021 7,043 2 View

I am working with crack propagation along with delamination using ABAQUS. Wether crack will start from a delaminated portion (cohesive crack) by XFEM?

I am modelling a SENB Beam with an interface. The interface is modelled with cohesive elements to permit delamination. The carck in the continumm is taken care by the XFEM. My doubt is the crack...

19 January 2021 4,827 1 View