How to analyse the 3D structure of protein from the surface of parasite

01 January 1970 1 6K Report

Hi,

I want to know how we can analyze the protein structure that coat on the surface of parasite.

If we make the recombinant protein for this protein or do computational method, the protein structure might not be the same.

Thank you

Md. Saiful Islam

Try to use VMD (Visual molecular dynamics) software. may be it will be helpful for you.

Badges
Science topic

More Fitri Amelia's questions See All

Can anyone help explain my ELISA Optimation curve?

I am trying to optimize a sandwich ELISA with antigen. I think, the higher antigen should give the higher OD. But in my case, the higher condition of antigen give the lower OD and it is increase...

01 February 2016 5,911 8 View

Modelling protein.

I am trying to model a protein using swissmodel then assess it with Procheck. When I try to minimize the energy, ramachandran plot result shows that the quality of the protein has decreased...

02 March 2013 5,203 3 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View