Here is my study, the part is cutted from x-axis, in other words its symmetric in X-axis. So after i applied job with the mirror command i will show bottom part also.
Here is my problem, in exapmle of Fish book's, it is applied YSYMM to bottom edge, but when i apply it, Abaqus gives too many attemp error. When i apply the BC as ENCASTRE, it gives the result. What should i do?
Note: Elasticy is 68.9e3 (mpa)
Dimensions of part in mm
Applied load from both side -1(mpa)(not sure if it is too high or not)