voltage unbalance in grid is important in grid connected converter.
How much is acceptable?
it's related to the to margin of your controller to stable the voltage
Não
how much voltage is wasted across the converter and inverter in a open loop condition. twice that much amount voltage will considered as unbalance
Is it true that null wire of grid and inverter case and solar panel frame are all connected to same ground? Can this connection result in a short circuit? Is there any requirements for this...
01 February 2017 5,056 1 View
As there is no model for such a transformer in Matlab, I need the exact equations of primary and secondary voltage and currents of this transformer and also the wiring connections so that I can...
06 July 2016 5,222 5 View
which kind of core material, wiring (delat-wye, delta-zigzag, ...) is appropriate for a 3-phase inveter according to the harmonic problems, acoustic noise, neutral overload supplying nonlinear...
31 December 2015 8,859 9 View
My understanding of IEC62040-3 is that for linear loads, RMS output voltage of UPS systems must be checked according to the specified criteria and for nonlinear loads, voltage of rectifier load...
31 December 2015 1,865 9 View
I am currently working with Solidworks. Solidworks s good for modeling assembly parts but it isn't strong with mechanical analysis. I worked with ANSYS and Abaqus but both of them are difficult...
10 November 2014 1,744 5 View
I think BLDC motor is used in hybrid car . Is this correct?
09 October 2014 1,358 0 View
NTC is nonlinear.
09 October 2014 5,323 7 View
For grid connected solar inverter
09 October 2014 9,733 1 View
CHP =combined heat and power for more inefficiency.
09 October 2014 2,036 9 View
We designed a grid-connected converter for wind. We saw in the grid side there is a DC current. Can anybody solve this problem?
09 October 2014 2,737 7 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
How to develop investments in renewable energy sources?
08 August 2024 5,112 3 View
I am analyzing cherts from different sources found within one specific geologic formation using ICP-MS/ES. My committee was asking this question about my analysis. I was not sure how to answer this
05 August 2024 7,902 3 View
I am working on developing a MATLAB Simulink model of Wind turbine with PMSG followed by MPPT Boost converter. I have gone through so many literature and videos but I am not finding clear solution...
03 August 2024 888 1 View
I am currently researching the impact of environmental toxins on children's health and would greatly appreciate insights from experts in the field. If you are an expert or researcher working on...
02 August 2024 2,627 1 View
I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...
31 July 2024 2,033 1 View
Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...
30 July 2024 9,824 2 View
What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?
29 July 2024 7,714 4 View
In some data sources it has been grouped in Q1 and some shows it is Q2.
29 July 2024 4,227 2 View