I have ftir spectrum response, how I interpret it?
FT-IR is very simple and rapid technique to perform this
analysis. It does not require complex sample preparation.
Spectrum TwoTM gives us the flexibility to run the samples in
liquid phase with 0.1mm path length cells. This application is
useful in oil or petroleum segment wherein we need to check
the quality of oil on the basis of carbon type.
Note: If sample has a large aromatic content (approximately 20
%) the paraffinic peak may become masked by adjacent peaks,
making accurate measurement difficult.
The calculation can be performed either manually or
using software calculations. Then tangents
are drawn across the transmission maxima on either side of the
peak being measured, and a vertical line is
drawn through the peak minimum. The intersection of these lines
gives the value of intensity Io and the intersection of the vertical
with the peak minimum gives value of I. The values are to be read
of Io and I for CA (1600 cm-1
) and CP (720 cm-1
). CN is calculated
from the difference
I have an absorbance graph. How can I convert it to transmittance?
31 December 2015 8,732 1 View
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
i am unable to interpret why its increases in start as shown in figure
11 August 2024 2,179 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View