I want to clean corning glass.
For black silicon production which RMS roughness is better?
01 January 1970 5,606 3 View
Actually, I want to find the relationship between XRD peak intensity with conductivity and transmission of any TCO (Transparent Conducting Oxide) material.
01 January 1970 1,341 3 View
I got XRD peak at 43.11 degree of silicon doped ZnO. For which component this peak aeries, SiO, SiO2, ZnO, Si, Zn?
01 January 1970 9,090 2 View
Both Si and Sn are tetravalent. SnO2 is conducting but SiO2 is insulating. Please give a reason with chemical
01 January 1970 4,875 0 View
I want to know about the plasma mechanism at the time of plasma etching of crystalline silicon wafers with atomic hydrogen plasma etching. In ICP-PECVD system only atomic hydrogen can etched...
01 January 1970 4,791 3 View
I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?
08 August 2024 8,915 0 View
Hi everyone I need a file with a dirty and clean potato image
04 August 2024 7,199 4 View
The module of the CAD detector is corona Veo. It has been idle for a long time. And it was not well maintained before idle. I have replaced the gas filters and flushed the system with a 50/50...
01 August 2024 7,805 0 View
We are working on a robot that cleans solar panels using fresh water supply and a rotating brush. We are trying to conserve as much water at possible by recycling the dirty water that is collected...
28 July 2024 5,778 2 View
I will polymerise Aniline on ITO glass WE, using 1M of H2SO4 and a potentiostat. However, I am not sure if I have to do the electrochemical polymerisation inside a hood. Is it necessary? Is the...
10 July 2024 2,937 3 View
Hi all, I am looking glass cilinders that have an open flat bottom and top. Preferably with the inner diameter in the range of 2 cm. It's similar to the ones found on multi-electrode arrays for...
06 July 2024 5,846 1 View
If we want to introduce a material similar to polymethyl methacrylate "with the characteristics mentioned in the next paragraph" that can be added to a precursor and create a composite, which...
03 July 2024 2,371 1 View
I use PDMS to build a microfluidic system, but it is not hardening at all, although I use TEOS as a cross-linker and also ATPES in a ratio of 1:10, and it's been 3 days at 80 degrees of 3 ml cast...
01 July 2024 604 3 View
Handbook [of] Heat Exchanger Fouling: Mitigation and Cleaning Technologies Hans Müller-Steinhagen IChemE, 2000 - Technology & Engineering - 382 pages
29 June 2024 8,259 0 View
Is direct contact of polllutant and catalyst needed? or indirect contact just like photocatalyst wrapped inside glass can also create hydroxyl radicals and elimnate pollutants near to its wrapped...
23 June 2024 3,249 5 View