please elaborate..thanks
Check the discussion
https://www.researchgate.net/post/How_to_calculate_the_ionic_conductivity_of_a_solid_or_gel_electrolyte
It is really fruitful for me..Thanks
Since graphene discovered (2004) later then CNTs (1991) it surpassed the CNTs in respect of many properties like adsorption and chemical catalysis due to high surface area available in case of...
07 August 2018 4,441 6 View
spectrum attached, please suggest analysis of these peaks
11 December 2016 9,896 0 View
Question is related to literature survey of research work
05 June 2016 3,610 4 View
important for Sol-gel prepartion
05 June 2016 446 4 View
research paper will be helpful
03 April 2016 4,872 1 View
Can I say particles and grains are same thing? If yes, would it be correct to say during sintering that two grains are going to be bonded?
10 November 2015 2,401 14 View
I have tried to synthesis the Nickel nanoparticles in eatable jelly via electrochemical reduction after performing the experiment I observe the black particles which can be confirmed by...
01 January 1970 1,856 8 View
I have dataset which shows the length of power lines. I need to classify the lines based on the line length. Is there a rule to classify the High voltage (HV) and low voltage (LV) lines based on...
03 March 2021 4,116 4 View
I am using a Sutter electrode holder for my patch clamp experiments, but I'm having trouble keeping positive pressure inside my electrode due to a leak out of the back of the holder. I have added...
02 March 2021 5,829 1 View
In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?
01 March 2021 1,923 3 View
I want to do RF sputtering of ITO on glass substrate using magnetron sputtering. what thickness do i need to make it good conductive layer to use it for PSC. Moreover, whats about thickness of...
01 March 2021 395 3 View
In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...
01 March 2021 2,207 3 View
When you use RIA, with a control the unknown sample with antibodies, you bare in mind the binding sites of the antibodies. However you still need to measure labelled antigen (radioactive) and not...
28 February 2021 2,133 3 View
I like to do project in laser measurement system. My objective is to eliminate or reduce the cosine error, abbe error in Laser measurement system. I have Rhenishaw XL80 system. Please tell the...
28 February 2021 4,890 3 View
I am conducting anodic electrodeposition of MnO2 onto a stainless steel substrate, using a platinum strip as a counter electrode. This is done galvanostatically, with the current held between 5...
27 February 2021 1,829 3 View
I am trying to classify and analyze the results of an SDS-PAGE based array for bacterial detection using machine learning, but I have trouble finding the best way to represent the results with...
27 February 2021 9,176 3 View
I am simulating helix antenna in hfss, right now, giving excitation with 50 ohms port. When I see the results of Z parameter (real). It shows lower than 50 ohms. Do not understand, if it can be...
27 February 2021 4,218 7 View