How to measure the coefficient of thermal expansion of single crystal Silicon using powder X-ray diffractometer??

04 April 2016 1 5K Report

research paper will be helpful

Badges
Science topic

More Zulfiqar Ali's questions See All

What are the superior properties which can only be seen/experienced in CNTs but not in Graphene, Graphene oxide or reduced graphene oxide?

Since graphene discovered (2004) later then CNTs (1991) it surpassed the CNTs in respect of many properties like adsorption and chemical catalysis due to high surface area available in case of...

07 August 2018 4,441 6 View

How may I analyze Raman peaks at 665 cm-1 and 900 cm-1 of AlN thin film?

spectrum attached, please suggest analysis of these peaks

11 December 2016 9,896 0 View

How could I confirm that my particular research work has not been publshed yet? what is the authentic website except science direct?

Question is related to literature survey of research work

05 June 2016 3,610 4 View

How electrical conductivity of gel can be measured using two graphite electrode?

please elaborate..thanks

05 June 2016 9,444 2 View

Please share...What are the names of Organic Gelating agent with properties?

important for Sol-gel prepartion

05 June 2016 446 4 View

Can I say particles and grains are same thing?

Can I say particles and grains are same thing? If yes, would it be correct to say during sintering that two grains are going to be bonded?

10 November 2015 2,401 14 View

How to separate magnetic nanoparticles from sticky organic eatable gel composed of carbohydrates and usual additives?

I have tried to synthesis the Nickel nanoparticles in eatable jelly via electrochemical reduction after performing the experiment I observe the black particles which can be confirmed by...

01 January 1970 1,856 8 View

What is the status of bread making and more bakery foods with the use of insect flour/powder?

Insects have been consumed by human diet since prehistoric times. At present, the idea of looking at insects as food has been getting traction worldwide, also in response to increasing food...

03 March 2021 6,223 5 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

How to grow E.coli on the low salt LB agar plate with 50 or 100ug/ml of Blasticidin?

Hello, I would like to ask how to grow E.coli which resists 50 or 100ug/ml of Blasticidin. I have tried many methods by using low salt Luria-Bertain(LB) agar plate. However, no colonies grow. Let...

01 March 2021 2,027 2 View

How to remove the residual PDMS on the silicon mold?

Incompletely cross-linked pdms are difficult to remove.

01 March 2021 798 3 View

Why am I not able to use all VEP programs for the in silico analysis of avpr1b SNP's?

Good day researchers I am busy analysing the predicted effects of certain SNP's in AVPR1b. When using the VEP prediction programs (SIFT, Polyphen, FATHMM, LRT, Provean, Mutation Assessor, and...

28 February 2021 5,197 1 View

What is the difference between genotype and haplotype data in the ped format?

Hi everybody In the ped format for genotype, alleles of any SNP are represented by two columns (one for each allele, separated by a space). Is a column sufficient for the haplotype to...

27 February 2021 1,965 1 View

How to replicate the well conditions of a crystal hit with 20%(w/v) isopropanol?

I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?

25 February 2021 9,761 1 View

How to search for crystal structure for material with atomic position labelled?

I am using the crystallographic open database and materials project to search for cif file but the exact structure is not mentioned or how can I deduce that the given structure and atomic position...

23 February 2021 6,723 2 View

Have anyone checked before Cyclic voltammograms of intial ITO substrate and E-teck?

As a beginner in electrochemistry, I tried to obtain cyclic voltamograms of commercial anatase powder deposited on an ITO substrate or on Eteck. After several attempts, I noticed that my cyclic...

23 February 2021 3,175 3 View

How to reduce static electricity of powder after lyophilization?

I am working on synthesizing and then purifying peptides using the SPPS system. After purification of the peptide, the peptide powder is obtained using a freeze dryer. When measuring the powder,...

22 February 2021 10,099 5 View