How does one determine the adequate sample size that will enable one to draw acceptable inferences from a population study. Is there any general rule?
10% of the total population is a good "rule of thumb" unless the total population are thousands or millions of individuals.
Best regards
the entire population is in hundreds of thousands
Please, what is the top three Journal repository service that is free from your personal experience
04 May 2019 3,862 1 View
what measures are you taking to increase the impact of your publication?
04 May 2019 4,884 6 View
Please recommend a good free article revision software for a Journal reviewer?
04 May 2019 884 6 View
SPSS VS E VIEW , which softtware is better for statistical analysis?
04 May 2019 9,919 2 View
Please distinguised colleagues, Anyone aware of post doc opening in canada for those in Bioscience?
04 May 2019 7,455 2 View
average particle size calculation from TEM
04 August 2024 2,921 1 View
Is this circle one of the rings?
03 August 2024 5,988 0 View
I am following Hainmueller, Hopkins, and Yamamoto's (2014) paper for my randomized conjoint experimental data analysis. The link to the paper is provided below. I received a comment from the...
02 August 2024 4,406 0 View
I want to draw ph diagram using Engineering equation solver EES for refrigerant R134a and R1234fy and some other. I don't know how to draw the multiple ph diagram on same dome or overlapping to...
30 July 2024 647 7 View
Is there a straightforward way to conduct a sensitivity power analysis for a Kendall's Tau correlation? I was considering using the sensitivity setting and "Correlation: point biserial model" test...
28 July 2024 6,133 8 View
Genome-wide association study (GWAS) Continuous traits: eg. Height Discrete traits: eg. Eye color
28 July 2024 286 0 View
...
24 July 2024 3,087 3 View
I want to study the differences between two groups: the treatment group and the comparison group. The total population consists of 60000 women in the treatment group, distributed across different...
21 July 2024 669 3 View
I forgot to autozero during the run (Size exclusion chromatography.) and later i realised i forgot to do that and the baseline was not zero but below zero (and in some cases it above zero). I...
15 July 2024 5,551 6 View
I was using Superose6 10/300 Gl column for purification of my target protein. the sample consists of various oligomeric state and i would like to identify the approximate elution volume where my...
15 July 2024 5,157 2 View