Hello everyone, I am still learning on defining the correct mesh size for my bone model. So far what I see is assuming the difference between one mesh size with another to be converged is less than 5%.
However, maybe there is more visible method that can be used, especially for complex 3D model such as bone model.
Thank you very much for all advice and references.
Thank you very much for your enlightenment and even sharing your article Sebastian Eberle . I will definitely look through your article.
Hello, Sebastian Eberle . I have looked at your paper, and there was written that you considered convergence when the results did not change more than 5% in three subsequent refinement steps. May I know your base in defining such assumption? Actually I have seen other papers using this assumption as well, but maybe there is any mathematical evidence that proves this assumption..? Nonetheless, thank you very much for sharing your work. It's a meaningful guide for my own research. Best regards.
- Badges
- Science topic
- Similar topics
- Filing