I just run the Hydrus model successfully, but now I want to extract or to know how much was infiltration, evaporation, recharge throughout the simulation. I am not sure which output file I must open in excel
Hi Stuart the T level file seem to be missing on my output files, please see the attached snapshot picture of my outputfiles
Right - my mistake. It should be in the T_level.out file - which I note is not shown in your file listing.
Assuming your model ran to completion, you might check the possibility that the output path for that file has somehow been changed in your installation.
When you run one of the simple tutorial examples to completion, where it the T_level file output?
Good luck.
In addition to the text files that are in the output folder by default, HYDRUS enables exporting all the nodes data of H, Theta, V, Temperature, ... as text.
However, to benefit from them in excel, you have to read the Meshtria.txt file to know each point coordinates, then the points are listed for each time step in TH.txt, V.txt, H.txt, .... in the folder. To make it easy and to avoid deletion after closing the file, ensure that your file has permanent directory.
please see the attached image for all steps.
best regards.
- Badges
- Science topic
- Similar topics
- Biological Science
- Kinesiology
- Running