I am not expert in this field

Dear Deepak,

The Same problem I face, still I am working on it.

one question: separately your NMOS and PMOS is running or not?

Dear Adhithan

I have done it already in 2015 ....if you need further information then see my attached thesis in research gate .

Dear Deepak,

Thanx for your kind reply. First i will read your thesis then i will work on it. Once again thanx.

Dear Deepak,

I try to download your thesis but it can't download properly. It download up to 9 Mb. So if possible mail your thesis this is my mail id [email protected].

may be some internet speed issue...pls try it again ....

Dear Deepak,

I also try to download your thesis but it only download up to 6 Mb. 

So, please may you re-upload it again?

thanks a lot ...

for the question:

i think it is better to use a tool rather than TCAD for inverter circuits. the tool is called PETE and can be found in nanohub. the tool takes the input I-V characteristics as well as C-V c\cs. and it performs a lot of circuit simulations

Thanks for your kind information

yes PETE is very good. i have included PETE results in my thesis too and compared it with LOOK UP base model for circuit simulations.

But that PETE tool have some limitations .

Dear Dr Deepak Kumar ,

I am facing the same problem as you mentioned in the question. If you have succeeded in your simulations, Could you help me to resolve the issue?.

Sure.. I can help u Rajan.

Msg me at 7906154716

Thank you very much for your reply Dr Deepak Kumar . Anyhow, I have managed to simulate a TFET inverter circuit using TCAD mixed-mode simulation. Still, there are difficulties with other circuits. If you don't mind, could I contact you in above-given number in future?

yes pls contact if u are facing with some difficulties

Respected Sir

I am also facing the problem of TFET Mixed-Mode circuit simulations for Inverter and unable to download your thesis too.

I am also facing the problem of TFET Mixed-Mode circuit simulations for Inverter. Can any1 help me, please?

It's solved long ago..pls read this.

https://www.researchgate.net/publication/349915806_Tunnel_FETs_and_Its_Application_to_Digital_Circuits

Thank you, Sir, for your reply.

Sir, I have read it...

But still, I am not able to plot the transient response. When I am giving the pulse input, I am not getting the inverted output for the inverter. But when I am giving the DC input, for example, either 1 or 0, I am getting the desired output. I have checked the individual n-type and p-type TFET; it is working properly. But I am getting the inverted output for the pulse input.

Dr Deepak Kumar

Dr Deepak Kumar

Sir, How to calculate the Iavg of the TFET inverter for the calculation of power consumption.

how can you insert

Sentaurus

Linear Systems

Inverters

Convergence

Simulation TAG in your question ???