How could i remove oxide layer like ZnO and TiO2 from a glass surface?

More Asmaa Tamam's questions See All

Strugglling with m6A dot blot any suugesstion ?

I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...

10 August 2024 8,539 5 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

19 July 2024 8,522 0 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

15 July 2024 2,414 1 View

What is the most accurate way to determine the energy gap of semiconductor materials? Is it better to use UV-Vis or PL measurements?

When preparing hierarchical zinc oxide ananostructure, the energy gap measured by PL was equal to (3.26 eV) While the energy gap value was determined by UV-Vis measurements (3.5 to 3.7 eV)

26 June 2024 7,505 6 View

What is the most accurate artificial urine recipe used in vitro for microbiological purposes?

I just found many protocols but not specific for bacterial growth

30 May 2024 6,305 2 View

How can I explain the acid base titration test for a PH responsive nanogel?

I have three nanogels.. The difference between them is the cationic monomer ratio... However, the test is giving me similar curve of the three formulations

27 May 2024 2,064 0 View

Question about XRD?

Hello, I was elaborating thin films from FeCl3 using a dip coater. These films were deposited on a glass sheet for 6 layers and then annealed at 500°C. However, XRD analysis did not yield any...

31 March 2024 9,413 3 View

Can I use two IRIS in the same plasmid expression cassette ?

I am trying to express m6A protein and a fluorescence one RFP in the piggyback vector. I was thinking first of using the P2A to separate between the m6A and the RFP protein but then I was afraid...

12 March 2024 9,713 0 View

How can I encapsulate cisplatin into a ph responsive polymeric nanogel?

I have synthesised a 100 nm sized cationic nanogel and I want to use it as a carrier for cisplatin and paclitaxel

03 March 2024 3,426 0 View

What tools needed to conduct areserch study about "burden of mothers in caring for child with colstomy" besides zarit burden interview scale ?

i'm preparing my protocol for master degree and it's my first time ,i need some help ,my reserch titel is "burden of mother in caring for child with colstomy"

02 March 2024 5,656 2 View

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

Fabrication of narrow glass capillary (inner diameter 200~500 nm)?

I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?

08 August 2024 8,915 0 View

Is there any way to quantify bacterial and fungal cells in their mixed culture?

I am working in fungal fermentation of soybean meal and there is bacterial growth in them at times. I am trying to quantify fungal cell counts and bacterial cells; but I haven't been able to do at...

07 August 2024 7,535 4 View

Stability of the Solar System: Insights from Einstein’s Equations ?

The stability of the Solar System is a complex subject that blends the classical framework of Newtonian mechanics with the modern insights provided by General Relativity (GR). Understanding this...

07 August 2024 2,569 1 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Who of all of you will help TPEOM to re-originate the Earths atmosphere to it original 5 atmospheric elements/gases?

Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...

06 August 2024 8,716 0 View

How much total RNA concentration to be extracted from sorted plasma cells from bone marrow of C57BL/6 mice for RT-PCR ?

i have sorted anti-NP specific plasma cells from bone marrow of C57BL/6 mice at certain times after immunization with variable counts and isolated total RNA using TRIZOL method for RT-PCR using...

05 August 2024 8,835 1 View

How to use Density Functional Theory to calculate carrier mobilities of solid system?

Hello, everyone. I have tried to determine carrier motilities of some materials, by Density Functional Theory, using Quantum ESPRESSO. There are a few methods to do it, like a package called...

04 August 2024 8,894 1 View

Alireza Lashkaripour

Hi Asmaa Tamam

You can check out these links, they can help you:

https://education.mrsec.wisc.edu/titanium-dioxide-raspberry-solar-cell/

https://technotes.alconox.com/industry/pharmaceutical/cleaning-tanks-titanium-dioxide/#:~:text=To%20remove%20TiO2%20(or%20ZnO,hotter%20than%2025%20deg%20C).

Xuhua Wang

The low concentration of citric acid was able to remove ZnO layer. To remove TiO2 layer, you could try sulphuric acid.

Carlos Araújo Queiroz

A TiO2 layer over glass can be etched with hot (to boiling) sulphuric acid.

You may want to check:

https://www.researchgate.net/post/What-is-the-best-method-to-ETCH-ZnO-films-from-glass-substrates