Why given matlab program is giving error? How to run it and give input to it?

06 July 2019 5,430 9 View

How to Plot Real Amplitude vs Frequency (Hz) plot by Simulink Block? Why my model is not generating the correct graph?

I have simulated a 2DOF Quarter Car Model (Figure Attached) for Step Input of 0.1m. The Weighted RMS acceleration obtained is 4.768 m/s2 . The Acceleration plot on Time Scale is also attached. I...

05 June 2019 5,364 3 View

What's wrong with my Fuzzy Controller?

My Fuzzy Controller is responding very slow, what is the reason. Do scaling factor is must for fuzzy. Is there any method to find scaling factor? Really frustrating slow response of fuzzy.

02 March 2019 9,615 3 View

No title

I am preparing the matlab codes for below mentioned seven interlinked equations: A = Ga * SI (1) OC = Goc*SI (2) SI = 2*t (3) ES= 3*t (4) dGa/dt = (alpha*SI)* (ES-A) (5) dGoc/dt = (betaa*SI)*...

10 November 2018 2,953 3 View

Which Simulink Block is Right Continuous RMS or RMS for Automotive Suspension Sprung Mass Acceleration in Given Solution?

A 2DOF Simulink Model Under Step Input of 0.1 m (Bump) is simulated as shown in figure attached. The continuous RMS block is used to find RMS value and stabilises at value of 0.9 m whereas simple...

08 September 2018 3,724 0 View

What will be Random Number Values for Given Simulink Model of Random Road Profile Generator?

Research Paper Attached here discuss about Simulink Model of Random Road Profile Generator . The Model has Simulink Block of Random Number, how this Random number values will be calculated for...

06 July 2018 5,526 0 View

How to Calculate Input values of Similink Road Profile Generator block Band Limited White Noise or Random Number?

My Simulink Model is not generating Random Road Profile as Per ISO 8608 for road Class-D. How to calculate or find values of Random Number Block, Fig.1 and Band Limited White Noise, Fig.2.

06 July 2018 9,137 0 View

What;s wrong with my matlab code to solve given equation?

how can I solve this equation by ode45 matlab code? Here z and zdot vary with time (t = 0:0.02:3) and simulation is also made for 3 seconds. My code gives answer different than that of Simulink...

05 June 2018 8,230 7 View

Is there any Simulink model of Inverse MR Damper is available?

Is there any Simulink model for Inverse MR damper is available? Or any simple Inverse MR damper model which can be easily created Simulink.?

01 January 1970 1,470 1 View

How to give input to given Matlab script for ISO 2631 frequency weighted acceleration in vertical direction?

01 January 1970 346 1 View

What do I do with DLS peaks that are from the buffer?

I'm looking at the aggregation of my protein sample using DLS. Unfortunately, my buffer (20mM HEPES) also results in a set of peaks. These are at approximately 1 and 1000 d.nm. The lowest peak...

01 March 2021 9,015 2 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

How can I get "Matlab/Simulink model for Droop/Reverse Droop controllers"?

Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...

22 February 2021 8,647 2 View

What low-cut filter (high Pass frequency) to be used for response spectrum (Tripartite plots) ?

What low-cut filter (high Pass frequency) to be used for the response spectrum (Tripartite plots)? I am currently working on differentiating between hard/soft site responses in Indo-Gangetic...

21 February 2021 9,273 2 View

Why are the modelled and circuit system different in response for controlled buck converter?

[Images are attached at bottom] I am currently working on a buck converter controlled by two different control methods, Reinforcement learning applied to find PID values & a lead-lag...

16 February 2021 5,060 10 View

What's support me on Simulink Matlab Model of Regenerative Braking in DC Traction ?

I have a thesis on Utilize the electrical power from Regenerative Braking in 750 Vdc Traction by simulation in the Program MATLAB Simulink. I made the Power Load flow from 24kV to Traction...

08 February 2021 2,532 1 View

FLIM Signal to noise ratio of a time series - can I use dark frames to measure noise?

I am doing an analysis on some FLIM data in the form of time series image stacks. I need their signal-to-noise ratio. Recording starts several picoseconds before the excitation pulse, so no sample...

08 February 2021 7,169 3 View

How to eliminate noise when using a sensor with instrumentation amplifier and giving it's output to Arduino?

When I am trying to implement a pressure sensor through instrumentation amplifier and then giving it's output to Arduino, I am getting garbage value due to noise, so how to eliminate it.

05 February 2021 8,598 11 View

Can we simulate light with matlab ?

Hi, I have to design a digital model of different types of lighting. Is it possible to simulate the lighting level from different sources (LED, incandescent, mainly fluorescence) with matlab...

28 January 2021 3,818 10 View