Having obtained data by mean of hotwire downstream of a circular cylinder, how can I get the power spectra plot as a function of wavenumbers?

02 March 2015 3,942 6 View

Where is the best place to locate the hotwire for vortex shedding measurement of a circular cylinder?

02 March 2015 7,717 7 View

What does it mean when two peaks appear in the FFT results using to find the vortex shedding?

I applied FFT to my hotwire data downstream of a circular cylinder to find the vortex shedding frequency, however two clear peaks appear in my final results. How can I say which one is the actual...

02 March 2015 1,904 28 View

How can I filter out the noise (due to the hot-wire holder vibration) from the hot-wire results?

02 March 2015 2,762 2 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Mediation path analysis - Can I run two seperate models?

I am wanting to run a serial mediation model with 2 x IVs, 2 x MVs, and 3 DPs (all continuous). Is it problematic to run 2 different models for each IV, keeping the MVs and DPs the same in each...

27 February 2021 5,681 3 View

High aspect ratio hexahedral mesh optimization solver?

I am interested in evaluating mesh optimization solvers that converge to high aspect ratio unstructured hexahedral grids. In other words, I am interested in a solver that optimizes warpage,...

26 February 2021 7,279 2 View

Has anyone used the Illumina ITS1 primer sets?

Hi everyone, Illumina provides a list of primers to amplify with high taxonomic coverage the ITS1 region for further fungal sequencing, but I cannot find the exact amount necessary of each...

25 February 2021 6,969 3 View

How do you mesh a thin solid in Fluent?

Hello, I have used the shell function on SpaceClaim to create thin solids for the model I am studying. These are contained within an enclosure for my study. I chose this approach as it avoids the...

24 February 2021 8,856 3 View

Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software?

Hi every one Is it possible to define biogas as a fuel in the reformer process(scwg) in Homer software? Biogas fuel is not available in the options thanks

23 February 2021 6,518 3 View

Physical-chemical formation of stalactites/stalagmites. what promotes the formation/growth of these structures?

I know, or think I do, the basic idea behind these natural structures, as from what I know they form due to water dripping from the top leaving a salt deposit behind. But started to wonder about...

22 February 2021 1,400 4 View

Is there a suitable way to confine cell attachment area inside a multi-well plate?

Are there any types of cylindrical cell culture inserts that are designed to confine cell seeding area? Say, if I'm using a 12 well plate (3.5 cm^2/well), but only want to seed cells in the middle...

22 February 2021 7,127 4 View

Repository for capture-seq raw reads?

I am a research tech in a wildlife genetics group and my PI and I are trying to figure out how/where to put raw reads in a repository. We have capture-seq NGS from Rapid Genomics. The post-doc who...

17 February 2021 7,575 2 View

No title

17 February 2021 4,217 3 View