How can i precipitate grafen quantom dot?

Atefe Arabpour @Atefe_Arabpour

01 January 1970 1 6K Report

I want to synthesis grafen quantom dot and i should sediment it. now how can i do it?

thank you

Fatih Oktem

Dear Atefe,

We are using grafen, CNT particles but we do not synthesise these materials. I do not know their production.

Best Regards,

Fatih

Badges
Science method

Similar topics
Chemistry, Organic
Synthesis

Is the black sediment consider as sand? If not, how can I filter it out?

Hi researchers! I'm working on soil texture analysis, and the end result for sand is doubtful because there is black sediment appearing after drying, as shown in the figure. Is it considered sand?...

30 July 2024 557 2 View

Prevent sedimentation and maintain the suspension of powder particles in the resin ?

Hello, I am experiencing an issue with mixing micro powder with resin in a 3D printer. The problem is that sedimentation occurs after a short period (about half an hour to an hour). Could you...

23 July 2024 1,672 0 View

I want to buy Hydrothermal Synthesis Autoclave from any European company. Can anyone suggest any company inside Europe?

Thanks

22 July 2024 1,143 3 View

Hi dear researchers, do you suggest the best and shortest path for chemical synthesis and green synthesis of magnetite(Fe3O4)?

Suggest the best and shortest route for the chemical synthesis and and green synthesis of magnetite(Fe3O4) The chemical synthesis should contain the least dangerous chemicals along with full...

21 July 2024 2,476 2 View

Im trying iodination of an arene, but only getting black precipitates, is there anyone with iodination experience who can advise?

Organic Synthesis. My student has been trying iodination of arenes (our goal is to iodinate p-phenylenediamine) following these literature procedures: 1. Synthesis 2004, No. 11, 1869-1873 using...

16 July 2024 6,630 1 View

What could be the possible reason that sintering of polycrystalline diamond fabricated with tape casting has suddenly started failing?

I make polycrystalline diamond with tape casting followed by HPHT sintering. When i sintered the samples up till May, the sintering was good. When i sintered the samples in June and July at the...

16 July 2024 3,212 5 View

How do I prepare a working stock solution of 14C sodium bicarbonate to get a final activity of 3uCi?

I need to make a stock solution for radioisotopic incubations of freshwater sediments to study dark primary productivity but I have some confusion as to how I calculate the concentration of 14C...

15 July 2024 5,898 0 View

Is there any possible explanation for the statement written below?

Low magenic concenrartion indicating enhanced chemical weathering associated with warm and wet climate in detrital sediments.

14 July 2024 1,381 4 View

65% saturation of ammonium sulfate in 100 ml? (for protein precipitation)?

Hi All: I need to precipitate extracellular protein from supernatant. A bit confused with ammonium sulfate calculation. Should I be adding: 1. 65g of ammonium sulfate in 100 ml of...

09 July 2024 5,508 0 View

How to disperse silverparticles in water?

I synthesize silver nanoparticles ，and reserve it in water. Then, when I sonicate it some minutes or longer ,it couldn't be dispersed, most of them aggregate .Otherwise ,when I sonicate several...

09 July 2024 7,335 0 View