I investigate 2 different geometries based on the same number of factors and responses. Factors' numeric values and ranges are the same for both cases, however, the responses' numeric values change over time.
For instance, I care about block-type and line-type structures as shown in the attached figures. The DOE is the same for both cases (attached figure) however the responses' numeric values vary.
Should I perform 2 DOE and mix them somehow comparing the results, or is there an option where I can perform only 1 DOE including both cases?
Jakub Jagielski
Perhaps you can add a categorical factor "the geometry". It will increase the number of runs, however in one desing you will take into account and you will compare both geometries.
0 votes
0 thanks
- Badges
- Science topic
More Antonios Dimopoulos's questions See All
Similar questions and discussions