Check the plastic strain in material property you defined. It must be arranged in ascending order, and be sure that there is no duplication in numbers.
Hi there, Where you defined your materal in property module and added your data, should be checked to see if the amounts you entered are in ascending order or not, make sure they are entered correctly.
As the error says 'The independent variables must be arranged in ascending order', there are some properties which are not properly written. Check all material properties. In my case, the mistake was that I had introduced the same line twice in a connector section.
Hi. Please check all values of the parameters that are defined. Probably one of those, has a strange and different value compare to the others. In addition, when a user is defining a curve, lack of consistency may case this.