How can I determine interface state density distribution of a Schottky barrier diode from a C-V characteristics?
You can perform the C-V measurements at two different frequencies (one about 10 kHz and another about 1 MHz) and then by the simple calculations (see attached reference) you can estimate the interface state density:
What is the best measurement method to determine bulk concentration, resistivity and mobility of thin films?
01 January 1970 7,221 12 View
front metal contact (Ag, Al or Au) solar cell such Ag/SnO2/Si/Al
01 January 1970 630 9 View
how to make a bridge between physics-technology and mathematics? How to motivate freshmen at the university to explain physical phenomena through mathematics and technological applications in...
01 January 1970 1,709 0 View
It is often that we report mean values or approximate values of grain size, band gap, measured current or any other parameter. Therefore, the researcher take directly values from papers and...
01 January 1970 7,679 0 View
Can we use Density functional theory to explain the conductivity type inversion inside semiconductors?
01 January 1970 7,985 0 View
MPc are metal phthalocyanine organic molecules.
01 January 1970 6,243 1 View
from n type to p type inside thin layer semiconductors based on oxide
01 January 1970 5,840 2 View
can anyone say which is the suitable synthesis method for p type ZnO thin film
01 January 1970 3,924 3 View
in aim to enhance current in contact of solar cell
01 January 1970 2,258 0 View
AZO is Al doped ZnO used in CZTS solar cell.
01 January 1970 8,415 6 View
Air moisture harvesting Air water collection devices
06 August 2024 5,473 2 View
I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...
05 August 2024 3,665 0 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...
30 July 2024 8,339 2 View
Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...
30 July 2024 906 2 View
Dear All, here is my question: if I have a 15-scans cyclic voltammetry performed with PalmSens, how can I obtain the charge passed during the process? Hopefully avoiding integrations,...
29 July 2024 3,733 5 View
DOS version.
29 July 2024 6,064 1 View
Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.
29 July 2024 4,971 1 View
While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...
26 July 2024 7,542 4 View
I am trying to drop cast 2D Materials on Glassy Carbon Electrode for Cyclic voltametry and EIS purpose. What would be best binders to use?
23 July 2024 5,776 2 View