In my process I have to maintain humidity 60-70%. How can I control the humidity inside the box of electrospinning process? Should I use humidifier?
Hi Sudipta, I have already worked with the electrospinning process, I recommend to you use a nitrogen enviroment (use a sensor too), but that is difficult, because you need a fully enclosed chamber, and normally the machine of electrospinning does not have this. I think that, if your humidity is not a very important parameter for your experimental work, you can depreciate.
Hello Sudipta,
You can use a humidity sensor and a humidifier/fogger used in agricultural applications. Then use a controller that controls this humidifier so that the humidity value stays within the limit that you want. Or even a simpler experiment could be to use the humidity sensor with standard analog output and manually monitor the values using any low-cost digital multimeter and adjust the humidifier to maintain the level that you want. You can try this and see how it works for you.
Best wishes!
-Prasanna Waichal
Hi Sudipta,
for humidity control you should use a DHT11 sensor, simply Arduino controlled. It's low cost, miniaturized and fast time response.
Good luck
Umberto
- Badges
- Science topic
- Similar topics
- Chemistry
- Nanotechnology