21 August 2023 1 2K Report

what is the formula is used for creating a anti flacking cycle

More Jayaprakash Polamarasetty's questions See All
How to calculate the dissociation energy of the oxides per unit volume?

I have prepared a Erbium Doped Borate glass and I am working on calculations of Elastic Moduli of the glass. I have referred some of the articles but I couldn't understand how they have...

23 May 2024 5,707 0 View

Can someone explain the procedure for Calculating Judd Ofelt Parameters?

I'm working on a project related to Luminescence Properties of Rare Earth Glasses (not Europium). I have read some articles related to Judd Ofelt Parameters, but I couldn't able to understand the...

26 March 2024 2,287 0 View

Why is my GELMA opaque?

I have been trying to synthesize high methacrylation GELMA using the following protocol : Precise Tuning of Facile One-Pot Gelatin Methacryloyl (GelMA... However, I find that my GELMA is very...

24 March 2024 1,070 2 View

Why is my GELMA hydrogel degrading in two days ?

Hi, I synthesized GelMA using carbonate buffer and maintained the pH at 9 throughout the synthesis. The carbonate buffer was made with MilliQ water. Subsequently dialysis was done using MilliQ...

28 January 2024 2,011 0 View

How can one calculate the refractive index from the absorbance data of the glass?

I have conducted an experiment on the UV Absorption Spectrum for my glass samples and I have obtained the Absorbance values for the corresponding wavelengths. Unfortunately, I did not measure the...

17 December 2023 5,071 3 View

Why fcc metal will not undergoes ductile to brittle transition temperature?

the fcc metal are not undergoing DBTT but bcc & hcp will undergoing and how it is happening

10 September 2023 6,549 0 View

How to find oxygen level(ppm) of solid ingot?

explain theory and formula for calculating oxygen level in solid ingot. During pouring of liquid metal into ingot mold, after solidification, forging and heat treatment operation to know oxygen...

06 September 2023 248 0 View

What is delta glaze?

why delta glaze is applying to titanium ingot before starting an forging operation

06 September 2023 8,716 0 View

What is relationship between ultimate test vs load capacity of lcf test machine?

according to A606 code specified that to carry out low cycle fatigue test machine capacity should minimum 45kn-100kn. why load capacity of machine is specified.

20 August 2023 7,156 1 View

What is use of extensometer in lcf test?

the purpose of extensometer in low cycle fatigue test

20 August 2023 5,242 1 View

Similar questions and discussions
How is energy cycled through the Earth's climate system and how do matter cycle and energy flow through the rock cycle?

How is energy cycled through the Earth's climate system and how do matter cycle and energy flow through the rock cycle?

08 August 2024 8,160 0 View

How to fix errors in my heat transfer steel structure with reinforced concrete slab model Abaqus?

I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...

07 August 2024 1,028 0 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,988 3 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 946 1 View

Could dyes amplify the spectrum of light to a specific wavelength?

I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...

05 August 2024 3,289 1 View

What should I do with parameters that are not relate to my simulation in MyLake model?

I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?

04 August 2024 1,535 1 View

How movement of energy in an ecosystem different from chemical cycling & movement of matter through an ecosystem differ from movement of energy?

How are the movement of energy in an ecosystem different from chemical cycling and movement of matter through an ecosystem differ from the movement of energy?

03 August 2024 6,134 0 View

Why does the flow of energy through the biosphere depend on the cycling of nutrients and matter and energy flow across the earth's subsystem?

Why does the flow of energy through the biosphere depend on the cycling of nutrients and matter and energy flow across the earth's subsystem?

03 August 2024 6,412 0 View

How does matter cycling and energy moving through the ecosystem differ from one another and cycling of matter through the ecosystem?

How does matter cycling and energy moving through the ecosystem differ from one another and cycling of matter through the ecosystem?

03 August 2024 2,558 1 View

What is the cycling of matter through ecosystems and how energy drives the cycling of matter in photosynthesis and cellular respiration?

What is the cycling of matter through ecosystems and how energy drives the cycling of matter in photosynthesis and cellular respiration?

02 August 2024 9,518 2 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close