Hi Would any body please suggest me the latest work on 5g physical layer especially which techniques are most suitable instead of OFDMA ?

Muhammad Hasnain Ilyas @Muhammad_Hasnain_Ilyas

06 June 2016 1 3K Report

Actually I am going to work on my Master's Thesis and In this master’s thesis, the plan is to model sufficiently large fragments of LTE PHY layer in Matlab/Simulink. So i need to help regarding the LTE model in matlab.

Khalid Al-Hussaini

Please, check this link:

https://www.nt.tuwien.ac.at/research/mobile-communications/vienna-lte-a-simulators/lte-a-downlink-system-level-simulator/

Badges
Science topic

More Muhammad Hasnain Ilyas's questions See All

How to implement LTE modulation and Demodulation on Asic/FPGA?

10 November 2016 5,371 1 View

flexibility of polymers chain

effect of double bond on the flexibility of polymers

07 April 2021 0 0 View

Formulation of polymer color flakes

I am writing to request some information for making polymer color flakes. I would appreciate the help.

17 March 2021 0 0 View

Why Austenite grains in steel show much more twinning than ferrite grains?

It is oftentimes said to be a distinctive metallographic trait that differentiates a fully austenitic and a fully felly ferritic steel without etching that might distinguish between two. Why...

02 March 2021 728 2 View

How does an AC-DC power supply Flyback Converter Based USB Charger Model using Matlab/Simulink looks like?

I am required to learn about Flyback converters and I got stuck not knowing to full design of the power supply flyback converter Based USB Charger Model using Simulink, especially the design model...

25 February 2021 5,435 2 View

Modeling viscosity using model of Chung?

Hello, As part of simulation of gases mixture and water, I need to calculate viscosity of the fluid components and I am using relationships proposed by Chung et al. (1988). The irony is while I...

25 February 2021 8,053 5 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

Are there any candidates for an Einstein's bare cosmological constant?

It is commonly accepted that General Relativity has its own 'bare' cosmological constant that contributes together with the cosmological constant resulting from vacuum energy density for an...

23 February 2021 5,448 8 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?

22 February 2021 3,697 1 View

How can I get "Matlab/Simulink model for Droop/Reverse Droop controllers"?

Dear Professors, Colleagues and Friends I need to develop a simple Matlab/Simulink model of reverse droop controller for a simple LV MG. How can I get a simple one to use it as a sample? A basic...

22 February 2021 8,647 2 View