Heating in Alkaline Melt.... ?

09 September 2017 1 6K Report

What is alkaline heating? How is etching of ceramics done using the method of Alkaline heating?

Alkaline melting of ceramics is a process where complex and insolubile aluminosilicate are transformed into low crystalline or amorphous less complex substances that will readily be soluble in strong acids or in HF, and sometimes in water.

Badges
Science topic

What is the reason for current dropping in OER , LSV curve?

I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...

10 August 2024 3,629 1 View

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM images?

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?

25 July 2024 5,482 2 View

Aqua regia not heating up?

I used Aqua regia to clean Au nanoparticles in the used glassware. But for some reasons, it is not heating up upon mixing. The color did change from no color to light orange. The Au NPs on the...

25 July 2024 4,390 0 View

What is the heating temperature that I can use to deactivate enzymes in bacterial extract exopolysaccharide without loss of the bioactivity of EPS?

What is the heating temperature that I can use to deactivate enzymes in bacterial extract exopolysaccharide without loss of the bioactivity of EPS? Hi I am trying to make the purification (by TCA...

22 July 2024 5,334 6 View

Appearance of crystallization peak in heating cycle of DSC test?

For which types of polymers, the crystallization peak in heating cycle of DSC test can be observed and for which types cant? In another word, when this exothermic crystallization can be observed...

18 July 2024 348 3 View

I need to know the required time for VDF heating with water for 50-80°C for PVDF Polymerization in ?

i need to know the required time

15 July 2024 4,796 2 View

Is there an explanation of why a negative photoresist take-off after contact with ferric chloride (like in the pictures) ?

Deep etching Negative photoresist Acrylate polymer Chemical etching Ferric chloride Crosslinking Resolution

11 July 2024 2,476 4 View

NH3/NF3/H2 Remote plasma Oxi/nit selective etching mechanism help ??

Hello, I am an Etch Engineer. I am performing etching with high T_ox/Nit selectivity using remote plasma. Etching plasma is formed using only NH3/NF3/H2. 1. I wonder if it would be advantageous...

11 July 2024 8,115 2 View