I am currently working on a project using abaqus direct cyclic and facing few issues.
The stabilized cycle response which is expected after few no of cycles is being shown as output at step time = 0 itself. Any particular reasons for this?
Your help would be appreciated.
Thanks in advance.
You need to see the input file carefully. The Abaqus output will depend on how is the direct cyclic is defined and what and how the cyclic properties are defined. You can share input file to diagnose the issue. Good Luck
Dear Vishwas Patil
If the stress was set as output field, you should create XYData and plot them by picking the elements at the load surface. In this way, you should be able to see the direct cyclic stress evolution.
See for instance Figure 2.5 in:
https://infoscience.epfl.ch/record/223625
Nicolò
Dear Vishwas Patil,
you might find useful information in my paper:
http://www.techno-press.org/content/?page=article&journal=sem&volume=79&num=5&ordernum=2
Please, email me at:
or send me a message on researchgate in case you have issues finding the paper.
Best regards and good luck with your work!
Danilo
- Badges
- Science topic
- Similar topics
- Instrumentation Engineering
- Instruments