7 Questions 6 Answers 0 Followers
Questions related from Vishwas Patil
I am currently working on a project using abaqus direct cyclic and facing few issues. The stabilized cycle response which is expected after few no of cycles is being shown as output at step time =...
11 August 2021 8,381 3 View
Hello everyone I am trying to simulate a cantilever beam with direct cyclic analysis approach. The pattern of the loading is given in the picture. However, at step time zero, the values of stress...
01 July 2021 3,738 0 View
For the case of crack propagation abaqus provides both the above methods. What is the difference between the two? The usual answers seen are just mentioning that one uses CZM and another LEFM. If...
21 June 2021 4,792 2 View
Hello everyone Recently I have been trying to import mesh created in hypermesh software and trying to import into abaqus. However, I am not able to continue, since parameters such as sections...
12 April 2021 2,200 7 View
Hello I am working on a project involving ABAQUS XFEM for stationary crack to obtain SIF and for crack propagation. However, I have encountered few problems. I have listed them below. 1....
08 April 2021 8,364 1 View
The motivation behind the question is that only young's modulus is available in tension for most of the materials, and compressive modulus is assumed equal to tensile modulus. There is a need to...
10 February 2021 7,701 3 View
This is required since the stress v/s crack length has to be determined
24 December 2020 3,635 1 View