Fiber Bragg grating?

Sorokhaibam Nilakanta Meitei @Sorokhaibam_Meitei

10 October 2018 0 5K Report

How to plot the graph of reflectivity Vs wavelength of the Fiber Bragg grating using couple mode theory equation in MATLAB?

Badges
Science topic

Similar topics
Mathematical Sciences
Graphs

More Sorokhaibam Nilakanta Meitei's questions See All

How to generate a spherical pressure wave from a source point in COMSOL Multiphysics software?

How to generate a spherical pressure wave from a source point in COMSOL Multiphysics software.

10 November 2019 7,578 1 View

Can consider a sinusoidal wave as a Partial discharge acoustic pressure wave?

Can consider a sinusoidal wave as a Partial discharge acoustic pressure wave.

08 September 2019 2,697 2 View

The amplitude of frequency in FFT doesn't match time-domain amplitude in COMSOL Multiphysics software?

Dear friends I am designing a underwater optical acoustic sensor Using COMSOL Multiphysics software. I would like to analyze the received signal signal by sensor in both the time domain and...

07 August 2019 2,806 3 View

How to export matlab program file to COMSOL?

03 April 2019 6,481 2 View

How to calculate the sensitivity of the acoustic optical sensor?

Dear friends, I am modelling an optical based underwater acoustic sensor to detect the acoustic sound wave which is induced inside the water-filled tank using COMSOL Multiphysics software. Due to...

03 April 2019 5,171 4 View

How to used contituity boundary condition in an acoustic wave propagation in an oil filled tank using COMSOL Multiphysics?

How to used contituity boundary condition in an acoustic wave propagation in an oil filled tank using COMSOL Multiphysics

11 December 2018 6,592 1 View

How to convert the output voltage(Volts) of Piezoelectric sensor into pressure (Pascal)?

Dear friends, I am working on an application where I need to convert the o/p voltage(in volts) of Piezoelectric acoustic sensor into pressure (in pascals). I wanna know how I would be able to do...

11 December 2018 5,215 8 View

Can used Piezoelectric transducer as an acoustic wave signal receiver sensor?

Dear friends, I am going to design a piezoelectric transducer as an acoustic wave signal receiver sensor using COMSOL Multipysics. Description of the model: In an air-filled rectangle box an...

11 December 2018 1,204 8 View

How to convert the output voltage(Volts) of Piezoelectric sensor into pressure (Pascal)?

Dear friends, I am working on an application where I need to convert the o/p voltage(in volts) of Piezoelectric acoustic sensor into pressure (in pascals). I wanna know how I would be able to do...

11 December 2018 5,195 8 View

2D model of optical Fiber Bragg Grating sensor using COMSOL Multiphonics?

Dear friends, I am going to desing an optical Fiber Bragg grating sensor for pressure and strain measurement using COMSOL software. But, I am new in this software so if anybody having any idea...

11 December 2018 9,015 0 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Help on understanding the implementation of Mori Tanaka method on MATLAB?

I am new to Micromechanics and having similar problem with understanding the implementation of the formula's. I would appreciate if anyone can guide me on how to go about getting a scalar value...

30 July 2024 969 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Please, what is the memory consumption of the Matlab function quad tree decomposition procedure [S = qtdecomp(I)] with respect to the input set I?

27 July 2024 5,455 2 View

Seeking MATLAB Code for Differential Evolution in Multilevel Thresholding Image Segmentation ?

Hello, I am a research scholar currently working on a project involving image segmentation, and I am interested in using differential evolution for this purpose . I would greatly appreciate it if...

25 July 2024 9,926 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

How to get LP fiber modes directly from Comsol?

Hi there, I'm new to modelling with comsol. I would like to ask if it is possible for comsol to output linearly polarized (LP) modes? I tried modelling a simple single mode fiber with an enlarged...

23 July 2024 4,019 3 View