Hi Everyone,

Hope you are doing well. I am trying to fabricate perovskite solar cells based on nip configuration structure. After patterning FTO Glass slides with Zn and 2M HCL, I am using heat-resistant Kapton tape to mask the targeted areas shown in the figure attached to spin coat subsequent layers. I have the following questions related to the fabrication process:

1: Does Kapton tape adhesive deposited on FTO and Etched side effect charge carrier collection and transportation to the contacts?

2: If yes, how can I remove the adhesive residue of Kapton tape without damaging the perovskite absorber layer?

3: Is there any other way to prevent the deposition of layers on bare FTO and etched surfaces?

Thank you for your time. I really appreciate your help!

More Abdul Sattar's questions See All
Similar questions and discussions